Scribd
Upload
2K views1 page

EL.CO Lift Control Panel Guide

The document provides instructions for connecting and configuring the SGV2 voice announcement board for a lift control panel. It describes connecting the board to a 24Vdc power supply and CAN bus communication lines. Voice messages can be stored on a microSD card in 8-bit or 16-bit PCM format at 44.1kHz or 48kHz sampling rates. The volume for each floor announcement can be adjusted separately in the menu. A night mode is also available to adjust volume from 10:00pm to 7:00am, allowing the volume to be turned off, set to 50% or left at the same level as daytime.

Uploaded by

minhasrana
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views1 page

EL.CO Lift Control Panel Guide

The document provides instructions for connecting and configuring the SGV2 voice announcement board for a lift control panel. It describes connecting the board to a 24Vdc power supply and CAN bus communication lines. Voice messages can be stored on a microSD card in 8-bit or 16-bit PCM format at 44.1kHz or 48kHz sampling rates. The volume for each floor announcement can be adjusted separately in the menu. A night mode is also available to adjust volume from 10:00pm to 7:00am, allowing the volume to be turned off, set to 50% or left at the same level as daytime.

Uploaded by

minhasrana
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

EL.

CO Micro2 Mechanical Installation – Connection of the Lift Control Panel

4.4 SGV2 BOARD (VOICE ANNAUNCEMENT)

LED
24V Input power supply 24Vdc, always ON
When communication with main board is OK this
OK led flashing
TERMINALS
+24,-24 Power supply 24Vdc
CANH,
Communication CAN BUS with main board
CANL
1 Speaker 1W,8Ω
SP,SP (Don’t connect 2 speakers will damage the board)

Adjust the volume from the menu

All voice messages can


stored in microSD
memory card.

All announcement files


must be:
8-bit PCM or 16-bit PCM
& sampling frequency:
44100Hz ή 48000Hz

*In menu FLOOR


each floor message
announcement is
possible to adjust
separately

**In menu NIGHT (from


22:00 to 7:00 a.m.)
Is possible to adjust the
volume of SGV2.
If adjust 10 then the
volume all day will be the
same. If adjust 0 from
22:00 to 7:00a.m. volume
will turn off. If adjust 5 the
volume will be at 50%.

[Link] HELLAS S.A. CONTROL SYSTEMS FOR LIFTS [Link] 35


49 Makrigianni Str, 14343 Athens, GREECE I Tel.: +30 2102711300, I Fax: +30 2102710497 I e-mail:info@[Link]

You might also like