Lecture 03: Computer Hardware CS 101: Introduction to Computing

Computer Hardware

Dr. Zahid Halim

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Computer Chips (-1-)

• Most electronic components inside a computer are

integrated circuits
– Thin slices of silicon crystal packed with microscopic circuit
elements
• Semiconducting materials are
used to fabricate a chip
• Types of chips:
– DIPs; DIMMs; PGAs;
SEC cartridge
• *The motherboard houses all essential chips and
provides connecting circuitry between them

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Computer Chips (-2-)

Dual
Dual In-line
In-line Memory
Package Module
(DIP) (DIMM)

Pin Single
Grid Edge
Array Contact
(PGA) (SEC)

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Microprocessor

• An integrated circuit designed to process instructions -

CPU on a chip

• The CPU has two parts

– ALU (arithmetic logic unit)
• Performs arithmetic operations
• Performs logical operations
• Uses registers to hold data being
processed
– Control Unit
• Directs and coordinates processing

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Random Access Memory (RAM)

• A temporary holding area for data, application program

instructions, and the operating system
– As you type, characters are held in RAM

• RAM is primary storage (main memory)

– Measured in megabytes (MB) or gigabytes (GB)

• Today’s computers have between 1GB and 9 GB of RAM

depending on software you use
– You can purchase additional RAM
– A computer can use disk storage to simulate RAM. This is called
virtual memory
• Not as fast as RAM ?

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Types of RAM
• RAM components vary in speed, technology, and
configuration
– SDRAM (Synchronous Dynamic RAM)
– RDRAM (Rambus Dynamic RAM)
– DDR
– DDR2
– DDR3

• Speed is measured in nanoseconds.

– 1 nanosecond (ns) is 1 billionth of a second
– It can also be expressed in MHz (millions of cycles per
second)

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Other Types of Memory

• Read-Only Memory (ROM)

– Type of memory circuitry that holds the computer’s startup routine
– Permanent and non-volatile
– Only way to change the instructions on a ROM chip is to replace the
chip
• Additionally, a computer needs a semi-permanent way of
keeping boot data
– CMOS (complementary metal oxide semiconductor) memory
holds data but requires very little power to retain its contents
• Retains important computer settings after you turn the power off
• Can be run by a battery on the motherboard

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Storage Devices

• A storage medium is the disk, tape, CD, DVD, paper or

other substance that contains data
• A storage device is the mechanical apparatus that records
and retrieves data from a storage medium
• Types of storage devices
– Magnetic Storage
– Optical Storage
– Solid State Storage

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Magnetic Storage
• Stores data by magnetizing microscopic particles on the disk or
tape surface
• Contains a read-write head
– mechanism in the disk drive that reads and writes magnetized particles
that represent data
• Example
– Hard Disk Drive [HDD]
– Floppy Disk
– Magnetic Tape

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Magnetic Storage : HDD

• Working of a hard disk

– Hard disk platter - a flat, rigid disk made of aluminum or glass and coated
with magnetic iron oxide particles
– Hard disk - one or more platters and their associated read-write heads
– Capacity up to 250 GB; Preferred type of main storage
• Limitations Platter
– Head crash - when a read-write head runs
into a dust particle or other contaminant
on the disk
• Head crash damages some data
on disk
• Triggered by jarring the hard disk
while in use
R/W
• Not limited to hard disks Head

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Optical Storage

• Stores data as microscopic light spots (lands) and dark

spots (pits) on the disk surface
• Advantage
– Less susceptible to environmental
damage than data recorded on
magnetic media
• Example
– CD [Capacity: 700 MB]
– DVD [Capacity: 4.7 GB;
Double Layered can store up to 8.5 GB]
– Blue-Ray [Capacity: up to 50 GB ]

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Optical Storage : CD / DVD

• Working of CD / DVD
– Recordable technology uses a laser to change the color in a dye layer
sandwiched beneath the clear plastic disk surface
– Rewritable technology uses “phase change” technology to alter a
crystal structure on the disk surface
– Much slower than hard disk
– Not a suitable replacement for hard disk yet

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing

Solid State Storage

• Stores data in a non-volatile, erasable, low-power chip

• Some solid state storage requires a device called a card
reader to transfer data to or from a computer
• Advantage
– Provides faster access to data than magnetic or optical storage
technology because it includes no moving parts
– Portable
• Example
– USB flash drive
– CompactFlash card

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing
Moore’s Law:
An Important Observation (-1-)
• Moore's law describes a long-term trend in the history of
computing hardware

– Since the invention of the IC in 1958, the number of transistors that can
be placed inexpensively on an IC has increased exponentially, doubling
approximately every two years

Moore's law is the observation that the

number of transistors in a dense integrated
circuit doubles approximately every two
years

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi

Lecture 03: Computer Hardware CS 101: Introduction to Computing
Moore’s Law:
An Important Observation (-2-)

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology, Topi