Scribd
Upload
1K views31 pages

Electronic Problems 1

This document appears to be a chapter from a textbook on electronic circuits. It contains questions and answers about diode circuits, including determining values like voltage, current, and resistance in various circuit configurations. The chapter covers topics like determining the resistance needed for a given diode current, analyzing half-wave and full-wave rectifier circuits, and calculating voltages and currents in networks involving diodes and resistors. The document is authored by Ahmed Shokry Soliman and focuses on analyzing diode circuits through solving example problems.

Uploaded by

ahmed mahmoud
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
1K views31 pages

Electronic Problems 1

This document appears to be a chapter from a textbook on electronic circuits. It contains questions and answers about diode circuits, including determining values like voltage, current, and resistance in various circuit configurations. The chapter covers topics like determining the resistance needed for a given diode current, analyzing half-wave and full-wave rectifier circuits, and calculating voltages and currents in networks involving diodes and resistors. The document is authored by Ahmed Shokry Soliman and focuses on analyzing diode circuits through solving example problems.

Uploaded by

ahmed mahmoud
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 31

Al-Azhar University

Faculty of Engineering
Department of Computer Engineering

Electronic Circuits

Prepared by:
Ahmed Shokry Soliman
https://www.linkedin.com/in/ahmedssoliman/
Chapter 2
Question 3

Determine the value of R for the circuit


of Fig. 2.153 that will result in a diode
current of 10 mA if E 7 V.
Answer of Question 3
Question 5

Determine the current I for each of the


configurations of Fig. 2.155 using the
approximate equivalent model for the
diode
Answer of Question 5
Question 6

Determine Vo and ID for the networks


of Fig. 2.156 .
Question 7

Determine the level of Vo for each


network of Fig. 2.157 .
Answer of Question 7
Question 10

Determine Vo and ID for the networks


of Fig. 2.160 .
Answer of Question 10
Question 18
Question 19

Determine Vo for the negative logic


AND gate of Fig. 2.165
Question 20

• Determine the level of Vo for the gate


of Fig. 2.166.
Answer of Question 20

• Since all the system terminals are at 10


V the required difference of 0.7 V
across either diode cannot be
established.
• Therefore, both diodes are “off” and
• Vo = +10 V as established by 10 V
supply connected to 1 k resistor
Question 21

• Determine Vo for the configuration of


Fig. 2.167 .
Question 22

• Assuming an ideal diode, sketch vi,


vd, and id for the half-wave rectifier of
Fig. 2.168 .
• The input is a sinusoidal waveform
with a frequency of 60 Hz. Determine
the profit value of vi from the given dc
level.
Answer of Question 22
Question 23

• Repeat Problem 22 with a silicon


diode (VK 0.7 V).
Answer of Question 23
Question 24

• Repeat Problem 22 with a 10 k load


applied as shown in Fig. 2.169 .
Sketch vL and iL
Answer of Question 24
Question 25

• For the network of Fig. 2.170 , sketch


vo and determine Vdc.
Answer of Question 25
Question 26

For the network of Fig. 2.171 , sketch Vo and iR.


Answer of Question 26
• Determine Vo and the required PIV rating of each diode for the
configuration of Fig. 2.173 . In addition, determine the maximum
current through each diode.
Question 30

• Sketch vo for the network of Fig. 2.174 and determine the dc


voltage available
Answer of Question 30
Question 32

• Determine Vo for each network of Fig. 2.176 for the input shown
Answer of Question 32

You might also like