Scribd
Upload
208 views

Measuring Synchronous Generator Model Parameters

This document describes procedures for measuring the parameters of a synchronous generator model through open-circuit and short-circuit tests. The open-circuit test varies the field current and measures terminal voltage to obtain the open-circuit characteristic curve. The short-circuit test varies field current while the terminals are shorted, measuring armature current to obtain the short-circuit characteristic curve. These tests allow determining the generator's internal voltage, synchronous reactance, and short-circuit ratio.

Uploaded by

malik karim dad
Copyright
© © All Rights Reserved
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
208 views

Measuring Synchronous Generator Model Parameters

This document describes procedures for measuring the parameters of a synchronous generator model through open-circuit and short-circuit tests. The open-circuit test varies the field current and measures terminal voltage to obtain the open-circuit characteristic curve. The short-circuit test varies field current while the terminals are shorted, measuring armature current to obtain the short-circuit characteristic curve. These tests allow determining the generator's internal voltage, synchronous reactance, and short-circuit ratio.

Uploaded by

malik karim dad
Copyright
© © All Rights Reserved
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 20

MEASURING SYNCHRONOUS

GENERATOR MODEL
PARAMETERS
The equivalent circuit of a synchronous generator that has
been derived contains three quantities that must be determined
in order to completely describe the behavior of a real
synchronous generator:
open-circuit test of the generator.

To perform this test, the generator is turned at the rated speed,


Terminals are disconnected from all loads,
Field current is set to zero.
Then the field current is gradually increased in steps, and the
terminal voltage is measured at each
step.
With the terminals open, IA = 0, so EA is equal to Vphase.
It is thus possible to construct a plot of EA or Vphase versus IF.
This plot is then called open-circuit characteristic (OCC) of a
generator.

With this characteristic, it is possible to find the internal


generated voltage of the generator for any
given field current.
A typical open-circuit characteristic is shown in Figure
Notice that at first the curve is almost perfectly linear, The
unsaturated iron in the frame of the synchronous
machine has a reluctance several thousand times lower than the
air-gap reluctance,

At first the resulting Flux increase is linear.

When the iron finally saturates, the reluctance of the iron


increases, and the flux increases much more slowly with an
increase in magnetomotive force.

The linear portion of an OCC is called the air-gap line of the


characteristic.
Short-circuit test.

To perform the short-circuit test,


Adjust the field current to zero again and short-circuit the terminals of
the generator through a set of ammeters.
Then the armature current lA or the line current IL is measured as the
field current is increased.
Such a plot is called a short-circuit characteristic (SCC) and is shown
in Figure
It is essentially a straight line. To understand why this
characteristic is a straight line, look at the equivalent circuit in
Figure when the terminals of the machine are short-circuited.
Notice that when the terminals are short-circuited, the armature
current lA is given by
and its magnitude is just given by
The resulting phasor diagram is shown in Figure

the corresponding magnetic fields are shown in Figure


Since Bs almost cancels BR, the net magnetic field Bnet is very
small .
Since the net magnetic field in the machine is so small, the machine
is unsaturated and the SCC is linear.
A plot of approximate synchronous reactance as a function of
field current is shown in Figure
The Short-Circuit Ratio

The short-circuit ratio of a generator is defined as the ratio of the


field current required for the rated voltage at open circuit to the
field current required for the rated armature current at short
circuit.

You might also like