Scribd
Upload
41 views

How To Install The Windows 7 On DOS Version E10-30

The document provides steps to install Windows 7 on a DOS version E10-30 computer. It involves: 1. Configuring the BIOS setup by disabling the USB XHCI Controller and saving changes. 2. Installing Windows 7 by booting from the USB CD/DVD-ROM and starting the installation process. 3. Obtaining and copying the XHCI driver to the hard drive, then reconfiguring the BIOS by enabling the USB XHCI Controller and saving changes.

Uploaded by

hamid khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
41 views

How To Install The Windows 7 On DOS Version E10-30

The document provides steps to install Windows 7 on a DOS version E10-30 computer. It involves: 1. Configuring the BIOS setup by disabling the USB XHCI Controller and saving changes. 2. Installing Windows 7 by booting from the USB CD/DVD-ROM and starting the installation process. 3. Obtaining and copying the XHCI driver to the hard drive, then reconfiguring the BIOS by enabling the USB XHCI Controller and saving changes.

Uploaded by

hamid khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 12

How to install the Windows

7 on DOS version E10-30


I. Configure in the BIOS setup
Configure in the BIOS setup
Step1: Power on your computer and press Fn+F2 enter BIOS
setup, Locate “Configuration” page, change “USB XHCI
Controller” from “Enabled” to “Disabled” as picture 1-1.

Picture 1-1 Select “Disabled”


Configure in the BIOS setup (Continue)
Step2: Press Fn+F10 saving changes and exit as picture 1-2.

Picture 1-2 Save and exit


II. Install Windows 7
Install Windows 7
Plug USB CD/DVD-ROM with Windows 7 disk, power on your
computer and press Fn+F12, select boot from USB CD/DVD-
ROM as picture 1-3, and then start to Windows install.

Picture 1-3 Boot from USB CD/DVD-ROM


Get XHCI Driver
Copy XHCI driver from USB driver disk to HDD or
download XHCI driver from LENOVO official
website to HDD
III. Configure in the BIOS
setup
Configure in the BIOS setup
Step1: Power on your computer and press Fn+F2 enter BIOS
setup, Locate “Configuration” page, change “USB XHCI
Controller” from “Disabled” to “enabled” as picture 1-4.

Picture 1-4 Select “Enabled”


Configure in the BIOS setup (Continue)
Step2: Press Fn+F10 saving changes and exit as picture 1-5.

Picture 1-5 Save and exit


Install XHCI Driver
Setp1:Power on and boot to win7 , there will
appear an unknown device.

Step2:Using TP to double click XHCI driver setup


file to install XHCI driver ,wait install complete

Step3:Reboot win7 and all USB ports can works.


Thank you!

You might also like