Scribd
Upload
275 views

D6&7DCompression Test

The document provides instructions for performing a compression test on Volvo construction equipment engines D7D/D6D and D12C/D9A. The test involves removing injectors and fuel lines, installing adapter tools, disconnecting the E-ECU fuse, and cranking the engine for 10 seconds at a time with 60 second intervals to test compression levels. Component numbers such as 9988539, 9998665, and 9998248 are listed for the required adapter tools.

Uploaded by

chanlin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
275 views

D6&7DCompression Test

The document provides instructions for performing a compression test on Volvo construction equipment engines D7D/D6D and D12C/D9A. The test involves removing injectors and fuel lines, installing adapter tools, disconnecting the E-ECU fuse, and cranking the engine for 10 seconds at a time with 60 second intervals to test compression levels. Component numbers such as 9988539, 9998665, and 9998248 are listed for the required adapter tools.

Uploaded by

chanlin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 2

Volvo Construction Equipment

Compression Test D7D/D6D


•Remove the injector fuel lines
•Remove Injector and install the adapter
Tool 9988539 •Tighten it with the nozzle holder
•Connect Nipple 9998665 & Tool 9988539
•Remove E-ECU Fuse
•Crank the engine for approx. 10 seconds
(max 15sec. at a time at intervals of 60sec.)

Nipple 9998665

Adapter 9998694
Service Manual Section 3:2
Component List 3: Fuses
No method available yet Voltage Feed E-ECU: FU18?
CST
25/02/2020 1
Volvo Construction Equipment
•Remove Rocker arm & VEB control valve
Compression Test D12C,D9A •Remove all injectors and install 6 adapters
9998248
•Tighten with the injector retaining yoke
•Install Rocker arm & VEB control valve
Tool 9988539
•Connect Nipple 9998665 & Tool 9988539
•Crank the engine for approx. 10 seconds
(max 15sec. at a time at intervals of 60sec.)

Nipple 9998665

Adapter 9998248

No method available yet


CST
25/02/2020 2

You might also like