Scribd
Upload
54 views9 pages

Anthropometry

ERGO

Uploaded by

Ques
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
54 views9 pages

Anthropometry

ERGO

Uploaded by

Ques
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 9

Anthropometry

Anthropometry
• The physical dimensions of human beings,
their anthropometry
• Anthropometry is the study and
measurement of human body dimensions.
Some Anthropometric Terms
• Height: A straight-line, point-to-point vertical measure
• Breadth: A straight-line, point-to-point horizontal measure
running across the body or segment
• Depth: A straight-line, point-to-point horizontal measure
running fore-aft the body
• Distance: A straight-line, point-to-point measure between
body landmarks
• Circumference: A closed measure following a body
contour, usually not circular
• Curvature: A point-to-point measure following a body
contour, usually neither circular nor closed
But no two people are the same
• Right, hence the use of percentiles
• There is no such thing as the “average
person”
• Percentiles are computed using the
formula below. The z values follow the
one-tailed normal distribution table
• See Percentiles.xls

Percentile  X  zS
Be careful!
• Anthropometric data is generally normally
distributed, but not always.
• Percentiles are based on the normal distribution,
so before using percentiles ensure that data is
normal.
• “Fun” way: Graph (Histogram) then either
Kolmogorov Smirnov Test, Chi-Square Test
• Other way: Statistica or other Stat packages
• Lazy way: Invoke the Central Limit Theorem (a
last resort)
Sources of Anthropometric Data
• Primary source: Get it yourself! Use an
anthropometer (to be taught to you in lab)

• Secondary source: Data gathered by an


external party, government agency,
military, NIOSH, etc.
Primary vs. Secondary
• Reliable since it focuses • Quick to obtain compared
on the particular with primary method
population concerned • Usually free
• Time-consuming since • Gathered for general
you need to get the data populations, may differ
yourself from population under
study
• Data gatherers must be • Usually obtained from the
well trained and military
measurement system • Finding Philippine data
must be documented and can be a challenge!
analyzed for validity • Time-dependent data
Now that we have data…so what?!
• Data is used in design guidelines for heights, clearances,
grips, and reaches of workplaces and equipment
• Generally, for heights and reaches, use lower percentiles
(design for extremes)
• Generally for clearances and grips, use lower percentiles
(design for extremes)
• Design for adjustable range
• Design for the average (a last resort)
• But the decision is all based on knowledge of the task
and a bit of common sense
• Data is also used in Biomechanics Models
Data Analysis for Anthropometry
• Comparing anthropometry of two
populations
-design was based on one population, you
want to find out if it is still apt for another
• Correlating anthropometry
– in case of lacking data for design,
established correlations may be used to
predict lacking data

You might also like