By Group 5: Sintu Kumar Sharma 0017 Avishek Mukherjee 0018 MD Ashraf Alam Khan 0019 Dali Das 0020
Uploaded by
Sunil SinghBy Group 5: Sintu Kumar Sharma 0017 Avishek Mukherjee 0018 MD Ashraf Alam Khan 0019 Dali Das 0020
Uploaded by
Sunil SinghBy
Group 5:
SINTU KUMAR SHARMA 0017
AVISHEK MUKHERJEE 0018
MD ASHRAF ALAM KHAN 0019
DALI DAS 0020
PIDstands for Proportional (P),Integral (I),
Derivative (D) controller.
PID controllers date to
1890s governor design.
PID controllers were
subsequently developed in
automatic ship steering.
One of the earliest
examples of a PID-type
controller was developed
by Elmer Sperry in 1911.
The first published theoretical analysis of a
PID controller was by Russian American
engineer Nicolas Minorsky, in (Minorsky
1922).
In the early history of automatic process
control the PID controller was implemented
as a mechanical device. These mechanical
controllers used a lever, spring and a mass
and were often energized by compressed air.
These pneumatic controllers were once the
industry standard.
PID controller is a generic The controller attempts to
control loop feedback minimize the error by adjusting
mechanism (controller) widely
used in industrial control the process control inputs.
systems. The PID controller algorithm
A PID controller calculates an involves three separate
"error" value as the difference constant parameters, and is
between a measured process accordingly sometimes called
variable and a desired three-term control: the
setpoint.
proportional, the integral and
a PID controller has
historically been considered derivative values, denoted P, I,
to be the best controller. and D.
The PID control scheme is
named after its three
correcting terms, whose
sum constitutes the
manipulated variable (MV).
The final form of the PID
algorithm is:
where
Plot of PV vs time, for three
values of Kp (Ki and Kd held
constant)
Proportional term
The proportional term produces an output value that
is proportional to the current error value. The
proportional response can be adjusted by multiplying
the error by a constant Kp, called the proportional gain
constant.
The proportional term is given by:
Integral term
The contribution from the integral term is proportional to
both the magnitude of the error and the duration of the
error. The integral in a PID controller is the sum of the
instantaneous error over time and gives the accumulated
offset that should have been corrected previously. The
accumulated error is then multiplied by the integral gain
and added to the controller output.
The integral term is given by:
Derivative term
The derivative of the process error is calculated by
determining the slope of the error over time and
multiplying this rate of change by the derivative gain
Kd. The magnitude of the contribution of the
derivative term to the overall control action is termed
the derivative gain, Kd.
The derivative term is given by:
Graphical Analysis
Plot of PV vs time, for three Plot of PV vs time, for three
values of Ki (Kp and Kd held values of Kd (Kp and Ki held
constant) constant)
The Characteristics of P, I and D controllers
CL RISE SETTLING S-S
OVERSHOOT
RESPONSE TIME TIME ERROR
Kp Decrease Increase Small Change Decrease
Ki Decrease Increase Increase Eliminate
Small Small
Kd Decrease Decrease
Change Change
Applications of PID
PID controllers are
applicable to many
control problems, and
often perform
satisfactorily without any
improvements or even
tuning.
It is used widely in the
process industry,
automation system,
process dynamics and in
particular the loop dead
time.
PID Controller Design for a DC
Motor
