Scribd
Upload
39 views

Atomic Absorption: Lab Techniques

Atomic absorption spectroscopy is an analytical technique used to determine the concentration of metals in solutions. It works by turning the liquid sample into an atomic gas using three steps: desolvation, vaporization, and volatilization. A flame or graphite furnace is then used to atomize the gaseous sample. Light from a hollow cathode lamp containing the metal of interest is passed through the flame/furnace. The amount of light absorbed can then be used to calculate the concentration of that metal in the original solution.

Uploaded by

Nirmal Kumar Pandey
Copyright
© © All Rights Reserved
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
39 views

Atomic Absorption: Lab Techniques

Atomic absorption spectroscopy is an analytical technique used to determine the concentration of metals in solutions. It works by turning the liquid sample into an atomic gas using three steps: desolvation, vaporization, and volatilization. A flame or graphite furnace is then used to atomize the gaseous sample. Light from a hollow cathode lamp containing the metal of interest is passed through the flame/furnace. The amount of light absorbed can then be used to calculate the concentration of that metal in the original solution.

Uploaded by

Nirmal Kumar Pandey
Copyright
© © All Rights Reserved
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 9

Atomic absorption

Lab Techniques

Dr. Maha Daghestani

Divination
In analytical chemistry, Atomic
absorption spectroscopy is a technique
for determining the concentration of a
particular metal element in a sample.
Atomic absorption spectroscopy can be
used to analyze the concentration of over
62 different metals in a solution.

technique
. The technique typically makes use of a
flame to atomize the sample, but other
atomizers such as a graphite furnace are
also used. Three steps are involved in
turning a liquid sample into an atomic gas:

steps

Three steps are involved in turning a


liquid sample into an atomic gas:
Desolvation the liquid solvent is
evaporated, and the dry sample remains
Vaporisation the solid sample
vaporises to a gas
Volatilization the compounds making
up the sample are broken into free atoms
.

flame
The flame is arranged such that it is
laterally long (usually 10cm) and not deep.
The height of the flame must also be
monitored by controlling the flow of the
fuel mixture. A beam of light passes
through this flame at its longest axis (the
lateral axis) and hits a detector.

The light
The light that is focused into the flame is
produced by a hollow cathode lamp.
Inside the lamp is a cylindrical metal
cathode containing the metal for
excitation, and an anode. When a high
voltage is applied across the anode and
cathode, the metal atoms in the cathode
are excited into producing light with a
certain emission spectrum.

The type of hollow cathode tube depends


on the metal being analyzed. For
analyzing the concentration of copper in
an ore, a copper cathode tube would be
used, and likewise for any other metal
being analyzed. The electrons of the
atoms in the flame can be promoted to
higher orbitals for an instant by absorbing
a set quantity of energy (a quantum).

This amount of energy is specific to a


particular electron transition in a particular
element. As the quantity of energy put into
the flame is known, and the quantity
remaining at the other side (at the
detector) can be measured, it is possible
to calculate how many of these transitions
took place, and thus get a signal that is
proportional to the concentration of the
element being measured.

You might also like