Scribd
Upload
7 views2 pages

2024n ct

The document outlines a practical assessment for Telecommunication Engineering Level 6, focusing on the installation of an IP PABX system. Candidates are required to perform tasks such as verifying equipment, connecting Ethernet cables, obtaining IP addresses, and configuring network settings. Resources provided include IP phones, Ethernet cables, a PoE switch, and a computer with internet access.

Uploaded by

josphat mbatha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
7 views2 pages

2024n ct

The document outlines a practical assessment for Telecommunication Engineering Level 6, focusing on the installation of an IP PABX system. Candidates are required to perform tasks such as verifying equipment, connecting Ethernet cables, obtaining IP addresses, and configuring network settings. Resources provided include IP phones, Ethernet cables, a PoE switch, and a computer with internet access.

Uploaded by

josphat mbatha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

©2024 TVET CDACC

061906T4TEL
TELECOMMUNICATION ENGINEERING LEVEL 6
ENG/OS/TLE/CR/06/6/A
Install IP PABX
Nov/Dec 2024

TVET CURRICULUM DEVELOPMENT, ASSESSMENT AND CERTIFICATION


COUNCIL (TVET CDACC)
t.c
om
ve

PRACTICAL ASSESSMENT
t
sy
ea

TIME: 3 HOURS

INSTRUCTIONS TO THE CANDIDATE


1. Figure 1 shows a block diagram of an IP PABX network. You are required to perform
the following tasks:
TASK 1: Verify you have all the equipment to perform the tasks.
TASK 2: Connect the Ethernet cable from the network switch to the IP phone’s
Ethernet port.
TASK 3: Connect the Ethernet cable from the network switch to a network with
internet access and power it ON.
TASK 4: Obtain the phone’s IP address. Check the phone’s display or menu to find
the assigned IP address. The IP phone should automatically obtain an IP
address via DHCP (Dynamic Host Configuration Protocol).
TASK 5: Using a computer connected to the same network as the PoE switch,
access the Phone’s Web Interface and log in using the default credentials.

Page 1 of 2
©2024 TVET CDACC

TASK 6: Configure network settings: static IP addresses, subnet mask, gateway, and
DNS servers

om
t.c
ve
t
sy
ea

Figure 1
2. You are provided with the following resources to perform the tasks1-6:

i. IP Phone
ii. Cat 6/Cat 5 Ethernet Cables
iii. Network PoE Switch
iv. Computer with a web browser and internet connection
v. Crimping tool
vi. RJ 45 connectors
vii. LAN network cable tester

Page 2 of 2

You might also like