DH-200P Fire alarm output and the expansion of joint board，it is one of the access controller
add-on modules, with the softwaresettings, mainly used to provide fire and alarm signal
output of thejoint. The module has a practical, simple interface, the design
performancecharacteristics of stability. With its power and relay instructions, maydirect
communication failures, is a good cost performance of the jointextension.
Thecharacteristics of the module
i. Four-alarm output, free to the hostcontroller to the definition of a door and the door to a
number of features.
ii. Can connect the output signal fire, theFire received the signal controller automatically
open their doors to all andhave a fire alarm records available for consultation.
iii. Support for the 'illegal intrusion' and'the door is not closed for a long time' and 'coercion to
enter,' and 'linkageto open the door' and 'invalid card' and 'fire' alarm linkage output, and
soon.
iv. Can be set for each output of the delaytime 0-6000 seconds.
Function Introduction
Applicable to access
DH-7001,DH-7002, DH-7004
controller
invalid break in alarm, long time unlocking alarm, intimidation break in alarm,
Can Control
unlocking linkage ouput, invalid card swiping alarm, integrated fire control alarm
This enhanced Alarm Output and Integrated Fire Control Expansion Panel only can
Should pay attention to
compat with the ACB series controller, and the software be V6.6 or higher version.
1-way input and 4-way alarm output, You can specify which function to which door
of the controled area, Can connect the fire control output, when fire signal received,
Output and input
doors in the controlled area will be open automatically, and five alarm will be
recorded.
Allow to change anti-intimidation password
Other Can set long time unclocking alarm time: 0-6000 seconds
Can set the time delay of each output from 0 to 6000
