Class 10 QP Electronics UT2 2024-25
Class 10 QP Electronics UT2 2024-25
CLASS 10 UT 2
SESSION 2024-25
SUBJECT – ELECTRONICS AND HARDWARE
Time Allowed: 2 hours. Maximum Marks: 40
General Instructions:
1. This question paper consists of 25 questions in 5 sections.
2. All questions are compulsory.
3. Section A consists of 10 objective type questions carrying 1 mark each.
4. Section B consists of 7 Very Short questions carrying 1 mark each.
5. Section C consists of 3 questions carrying 2 marks each.
6. Section D consists of 3 Long Answer type questions carrying 3 marks each.
7. Section E consists of 2 Long Answer type questions carrying 4 marks each.
SECTION A
Q1 Which of the following is not the type of mixer? 1
a) Stand mixer b) Dough mixer c) Spiral mixer d) Planet mixer
Q2 Which part protects the mixer from overload? 1
a) Auto Switch b) Automatic Protector c) Overload Switch d) Auto Overload
Protector
Q3 OLP stands for: 1
a) Automatic over protector b) Over load protector
c) Over level protection d) Over line protection
Q4 Which of the following are the types of juicer? 1
a) Centrifugal juicer b) Masticating juicer
c) Citrus juicer or Reamer d) All of the above
Q5 Which of the following is not the part of juicer? 1
a) Plunger b) Drum lid c) Hopper d) Straight Wiper
Q6 Which of the following is to control the speed of mixer. 1
a) Overload switch b) Rotatory switch c) Power switch d) Control switch
Q7 Which of the following is not the type of mixer 1
a) Planetary mixer b) Stand mixer c) Spiral mixer d) Pipe mixer
Q8 Which of the following is NOT an element of communication within the communication 1
process cycle?
(a) Channel (b) Receiver (c) Sender (d) Time
Q9 You need to apply leave at work? Which method of communication will you use? 1
(a) e-mail (b) Poster (c) Newsletter (d) Blog
Q 10 By which action can senders send their messages? 1
(a) Gestures (b) Speaking (c) Reading (d) Writing
SECTION B
Q 11 If the jar of a mixer/grinder is leaking from the bottom, it can be due to worn out blade shaft. 1
Q 12 A defective motor leads to an excessive vibration in the mixer/grinder. 1
Q 13 To remove the discoloration of plastic parts of a juicer, clean them with bleach. 1
Q 14 If the juicer is placed on an uneven surface, it will not start. 1
Q 15 Rotatory switch regulates the speed of the mixer motor. 1
Q 16 Armature is a part of motor. 1
Q 17 Stator is a dynamic part of motor. 1
SECTION C
Q 18 What are the types of mixers? 2
Q 19 Name the parts of mixer. 2
Q 20 List the parts of motor. Also specify the type of motor used in mixer. 2
SECTION D
Q 21 Draw a flowchart of process of communication in detail. 3
Q 22 Describe any three processes of communication. 3
Q 23 Describe any three types of verbal communication. 3
SECTION E
Q 24 Draw any four common signs used for Visual Communication. Explain what each conveys 4
and where did you see it?
Q 25 Write down four examples of positive feedback. 4