Scribd
Upload
58 views1 page

Engineering Design and Graphics With Solidworks 2016 PDF

The document outlines various topics related to assembly creation and dimensioning in design, including steps for creating assemblies, managing bill of materials, and editing title blocks. It also covers dimensioning conventions, common errors, and tolerance creation techniques. The content is structured into chapters with specific objectives and detailed instructions for each topic.

Uploaded by

elffsknn
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
58 views1 page

Engineering Design and Graphics With Solidworks 2016 PDF

The document outlines various topics related to assembly creation and dimensioning in design, including steps for creating assemblies, managing bill of materials, and editing title blocks. It also covers dimensioning conventions, common errors, and tolerance creation techniques. The content is structured into chapters with specific objectives and detailed instructions for each topic.

Uploaded by

elffsknn
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

5-6 Mate 305 6-9 Accessing the Design Library 384

To Create the First Assembly 305


To Create a Second Assembly 307 6-10 Thread Pitch 385
To Create a Third Assembly 310 6-11 Determining an External Thread
5-7 Bottom-up Assemblies 310 Length—Inches 385

5-8 Creating an Exploded Isometric Assembly 6-12 Smart Fasteners 390


Drawing 315 6-13 Determining an Internal Thread Length 393
5-9 Creating an Exploded Isometric Drawing 6-14 Set Screws 397
Using the Drawing Format 318 6-15 Drawing a Threaded Hole in the
5-10 Assembly Numbers 320 Side of a Cylinder 398
5-11 Bill of Materials (BOM or Parts List) 322 6-16 Adding Set Screws to the Collar 402
To Edit the BOM 324 Chapter Projects 404
To Add Columns to the BOM 326
To Change the Width of a Column 327 CHAPTER 7 Dimensioning 439
To Change the Width of Rows and Columns 328
To Change the BOM’s Font 328 Chapter Objectives 439

5-12 Title Blocks 329 7-1 Introduction 439


Revision Letters 330 7-2 Terminology and Conventions—ANSI 440
To Edit a Title Block 330 Some Common Terms 440
Contents vii

Some Dimensioning Conventions 440 8-4 Understanding Plus and Minus Tolerances 511
Some Common Errors to Avoid 441 8-5 Creating Plus and Minus Tolerances 512
7-3 Adding Dimensions to a Drawing 442 To Add Plus and Minus Symmetric Tolerances Using
Controlling Dimensions 445 the Dimension Text Box 514
Dimensioning Short Distances 446 8-6 Creating Limit Tolerances 515
Autodimension Tool 448
To Create Baseline Dimensions 451 8-7 Creating Angular Tolerances 516
:

You might also like