Iotal o.

ofOuestion 5|

P6387 |lotal \o. of Pages : 2

|6155-45
S..B.Se. (Coputer Science)
ELEC IRONICS
ELC- 241:Fnbedded System Design
(2019 Patiern)(Semester - IV)(Paper - I) (24321)

Time:2 Hours/ /Max. Marks : 35

Instructions to tine andidates:
) 0.1is compuisor1:
2) Sove any hree questions from Q.2 19 Q.5.
3 Figures to the right indicates full marks.
) Vear dagrams must be drawn whenver necessary.
Use of caleulator is allowed.
Q) Atempt any five |3 x 1 = 5]
a) What is FPGA?

b) W hat is the use of crystal oscator in SoCS?

c) List any two operators ifpython
d) State use of HDMIport m Respberry Pi.
e) What is the use of ord (x) instruction in python?
f) State significance of pull down resistor in LED interfacing to Respberry Pi.

Q2) Answer the following: |2_x5= 10]

a) What is interrupt controller? Write a python prográm for addition of two
numbers.
b) Draw the proper circuit diagram for interfacinguf LED toGPIO24 pin
of Respberry Pi & write a python program forblinking of LED.

03) Answer the following: |2 x 5 10]

a)With neat block diagram explain single Board computer.
b) Explain Branch prediction &folding.

PTO.
 (Q4) AIINWer thc
folowing |2 x 5 = I01
a)
What are stand:rd
datatypes in pvthon? Ixplain any two.
b)
With proper circuit diagram
plainGSM interlacing to
Respberry Pi.
Q5) Write ashort note on
any four of the
following |4 x 2½= 10|
a)
MicroprocessOr.
b) BcagicBone Black.
c) Digital signal processor. (DSP)
ANOI7371
d) CPUpipcline.
12:202:

e) Library functions inpython.

) Ethernet.

91
202
1233:35

7371

ANO17
 TotalNo. of Questions: 5) SEALNo.
|Total o. of Pages : 2
P5147
|58234-405
S.Y. B.Sc. (Computer Science)
ELECTRONICS
ELC-24: Embedded Svstem Design
(2019 Pattern) (Semester - IV) (Paper - )
Time : 2Hours/ /lac. larhs : 35S
Instructions to the candidates:
) 0is cempulsor.
Solve any Three questions from Q.2 to Q.5.
3) Figres lo the right indicates full marás.
4) Veat diagrams must be drawn wherc necessur):
l'se of calculator is ulioweL.

O!) Attept any five. |5 x l = 5)

Define un Embedded stven
b) Which processor Is ued in
Rafoeny pi
C) What is the d1tference between Lists and Tuples
d) What is the use of time' funcuon?
e) How physical numberng schene is selected on
Raspberry pi?
Write the use of GSM module.

02) Answer the toliowing :

a)
2x5= 10|
Explain follow ing tunctions of Py thon
[3]
eval (str)
I) GPI0.input (channelb
IiI)
GPI0-setup (channel. GPIO.OUT)
ii) Write Python
program for LED intertacing to Raspbery pi[2)
b) Explain any two types of SBC in detail. List the
disadvantages of SBC. advantages and

PT.O.
 03) Answer the tollowg
|2 x 5= 10)
Wrnte the functions of tollow ng hlocks of Raspherry pi
HDMI
MIcro SD Card
I USB ports
I\) Etheraet
V) Processor
b) Lst d1ffetent ty pes of operators used in Python Explain any three
operators in dea,l

04) AnsWer the following |2 x5 = 10]

Draw the ncat diagram of architecture of SOC Explan any three blocks

b) Explan ditterent types ol Network Access devices used for SBC along
with their features.

D5 Wite a slhort note on any tou af the tolowlg: |4 x 2.3 = :0)

a) Ruspberr) P and Beagle Bon SBC.
b) ARM I|76JZF-S.
c) GPIO functions.
d) Standard data types used in Python.
e) elif statement.

Python Dictionary.
 SEAT N0. :
Total No. of Questions : 5|
|Total No. of lages : 2
PC-1576

|6328| - 45
S.Y.B.Sc. (Computer Science)
ELECTRONICS SCIENCE
ELC-241: Embedded System Design
(24321)
(Revised 2019 Pattern) (Semester - 1V)(Paper - I)
/Max. Marks : 35
Time:2 Hours/
lnstructions tothe candidates:
1) Q
No. I is compulsory
2) Solve any three questions from0. 21o Q. 5.
3) Figures to the right indicate fullinarks.
4) Neatdiagrams must bedrawn whenever necessary.
Use of calculotor is allowed.

Q1) Attempt any five:

a) Write full form of SBC?

b) State use of UART in communication?

c) Which port is used to connect monitor in Raspberry Pi?

d) List any two types of SOC»S?

e) Whichoperating system is popularly used in Raspberry pi?

) Differentiate between list and tupple?

 |2 x 5 = 10|
(02) Answer the ollowing :
programming lo nterface
a) Txplmany five IO functio)s uscd in python
hardware?

b) Draw and explain block diaoram of embedded system?

03) Answer the following: |2 x 5= 10|

a) With propcr circuitdiagram explain LCD interfacing to raspberry Pi?|S|

b) i) Write difference between microcontroller and SBC?(any - 3) |3|

i) State parameters ofARMILJ6HZF-S? |2|

04) Answer the following : |2 x 5 = 10|
a) i) Write a python program tofind perimeter of reactangle 3|
Draw a circuit diagram ofswich interfacing with Raspberry Pi?|2|
b) Explain basic architectur of SOC?
Q5) Write short note on (any four) of the
following : |4 x 2.5 =10|
a) Logical operators in Pyihon.
b) Steps for installation of
Raspberry Pi operating system.
c) Finger print sensor.

d) Difference between Soc and processor on chip

(any - 3)
e)
Teachnical specifications of Beogle Bone Black
) Wi - Fi

|6328|-45 2
 Total \o. of Questions : 5| SEAT No.
|Total No. of Pages:
PI298
|6055)-203
S.V.B.Sc. (Computer Science)
ELECTRONICSSCIENCE
ELC- 241: Embedded System Design
(2019Patter) (Senester - IV)(24321) (Paper - )
Time:2 llours/ |Max. Murks : 35
Instructions to the candidates:
) Q1 is compson.
2) Solve any three questions from ).2 1o Q.5.
3) Figures tothe right indicates full marks.
Vegt diagrams must be drawnwhenerer neccessary.
5) Useof calculator is allowed.

Q1) Altempl any Five |5x1=5]

) State use of UART n communication.
b) What does theterm flexiblity relaed to soc's?
) State role of watchdog module in soc's.
d) Whal isthe use of 'print strlol nstrution in pyhon?
e) List any two standard datatypes in python.
State use of 'GPIO. Cleanup ( funcion.

02) Answer the tollowing. [2x5=10]

a) Explain embedded system with a general layout diagram.
b) Draw the proper interfacing diagram of PIR sensor to Raspberry Pi.
Write apython program for derection of motion.

03) Answer the following.

[2x5=10]
a) Explain Branch prediction and folding concept.
b) List any four assignment operators in python. Write a
python program
for multiplication of two numbers.

04) Answer the following.

a) What is the library function? Siate the
[2x5=10]
use of following instructions.
i) print tuple [o]
ii) dict (d)
ii) time ()
b) With proper circuit diagram exolain LCD
interfacing to Raspbery Pi.
PT.0.
Q5) Write short note onany four of the tollowing. |4x2.5=10]
a) SOC.

b) Microcontroller:.

c) Digital signal processot

d) Network on achip.
e) NOOBS.
C AA
f) Bluetooth module.
202

4 9

199

117

1V3e7i1