Douglas Street Campus
Cork College of FET
Examination Paper
Component Name: Engineering Drawing
Component Code: 5N1607
Exam Session: Summer Year: 2023
Course(s): Motor
Teacher Name(s): P O Sullivan
Class/Group: MO
Weighting: 40%
Time Allowed: 2.5 Hours
Learning Outcomes Assessed: 1,3,4,7,12,14,17,18.
Instructions to Candidates:
a) Attempt all questions.
b) Drawings and sketches should be in pencil unless otherwise stated.
c) Where dimensions are omitted, they may be estimated.
d) Credit will be given for neat orderly presentation of work.
e) Candidates should work on one side of the paper only.
f) Title block including name, date, question number should be drawn
on each drawing sheet used.
All dimensions are in millimetres.
Page 1 of 5
Douglas Street Campus
Cork College of FET
Q.1 (60Marks)
Details of a Mug Stand are given in Fig 1 below.
a) Make the following drawings to scale of assembled components in first angle
projection.
(i) A sectional elevation on section plane AA. (20marks)
(ii) A half plan projected from (i). (20marks)
(iii) Describe the design characteristics employed in construction and the role
of different stakeholders employed in designing and making the Mug
Stand.
(10 marks)
b) Insert the following on the drawings:
(i) Title: Mug Stand. (2 marks)
(ii) ISO projection symbol. (2 marks)
(iii) Four leading dimensions. (2 marks)
(iv) Describe two materials suitable to make this project. (4 marks)
Page 2 of 5
Douglas Street Campus
Cork College of FET
Fig 1.
Page 3 of 5
Douglas Street Campus
Cork College of FET
Q2. (30 marks)
Draw a radial motorcycle cam with a minimum radius of 20mm and anti-clockwise rotation
to impart the following motion to an in-line knife edge follower:
0o - 30o Dwell.
30o - 120o Rise of 70mm with Uniform Velocity.
120o - 180o Fall of 14mm with Uniform Velocity.
180o - 360o Fall of 56mm with simple Harmonic Motion.
(a) Draw the displacement diagram. (12 marks).
(b) Draw the profile of the cam (12 marks.)
(c) Name three machines that use cams. (6 Marks)
Page 4 of 5
Douglas Street Campus
Cork College of FET
Q 3. (30 marks)
Fig.2 shows the elevation, plan and end view of a circular pipe intersecting a square
section pipe from an air ducting assembly. Height of figure 90 mm (circular pipe length).
Circle Diameter 70 mm. Overall Length of square section 100 mm. Length of each side of
the square duct is 40 mm.
(a) Draw the given plan, elevation and end view. Lines of intersection must be shown
on elevation. (10 marks)
(b) Draw a surface development of square pipe section of ducting.
(16 marks)
(c) Incorporate best Drawing office administrative practice in your answer
(4 marks)
Page 5 of 5
