Scribd
Upload
6 views

CE2201 Structural Analysis Assignment-1

This document is an assignment for the course CE2201: Structural Analysis at IIT Patna, due on April 4, 2025. It includes six problems related to structural analysis methods such as moment area method, conjugate-beam method, unit load method, and Castigliano's theorem, with specific parameters provided for calculations. Each problem has assigned points, totaling 100 points for the assignment.

Uploaded by

aspirantshivam2k4
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
6 views

CE2201 Structural Analysis Assignment-1

This document is an assignment for the course CE2201: Structural Analysis at IIT Patna, due on April 4, 2025. It includes six problems related to structural analysis methods such as moment area method, conjugate-beam method, unit load method, and Castigliano's theorem, with specific parameters provided for calculations. Each problem has assigned points, totaling 100 points for the assignment.

Uploaded by

aspirantshivam2k4
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Department of Civil and Environmental Engineering, IIT Patna Assignment-1

CE2201: Structural Analysis (Spring 2025) Due Date: 04.04.2025

Problem-1: (20 points)


For the beam shown in Figure-1 determine the slope at point A, deflection under point C and
D. Use moment area method for calculation and assume E = 205 GPa and I = 25 × 106 mm4.

Figure-1

Problem-2: (15 points)


Determine the force F at the end of the beam C so that the displacement at C is zero. EI is
constant and beam is shown in Figure-2. Use the conjugate-beam method.

Figure-2

Problem-3: (15 points)


Using unit load method, determine the horizontal displacement at support D for the frame as
shown in Figure-3. Adopt the following values for E = 200 GPa and I = 300 × 106 mm4.

Figure-3
Problem-4: (15 points)
Use unit load method to determine the vertical displacement at joint A for the truss given in
the Figure-4. Adopt the following value of E = 29000 ksi and cross section area of each member
is given in the Figure-4.

Figure-4

Problem-5: (15 points)


Using Castigliano’s theorem, determine the prop reaction ‘R’ of the cantilever beam propped
at the free end and loaded as shown in Figure-5.

Figure-5

Problem-6: (20 points)


Using Castigliano’s theorem to determine the vertical displacement of joint C of the truss under
loading, as shown in the Figure-6. Each member has a cross-sectional area A = 300 mm2 with
Young’s modulus E = 200 GPa.

Figure-6

You might also like