Scribd
Upload
32 views

How to programm Toyota key

The document outlines a procedure for programming vehicle remote controls and registering new keys. It details the necessary conditions, steps for entering programming modes, and how to confirm the successful registration of remotes and keys. Specific instructions are provided for vehicles from 2002 and later, including key cycling and door operations.

Uploaded by

Mono
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
32 views

How to programm Toyota key

The document outlines a procedure for programming vehicle remote controls and registering new keys. It details the necessary conditions, steps for entering programming modes, and how to confirm the successful registration of remotes and keys. Specific instructions are provided for vehicles from 2002 and later, including key cycling and door operations.

Uploaded by

Mono
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Procedure

1. The vehicle should be in the following condition: A. The key is NOT inserted in the ignition. B.
The driver's door is open. C. The driver’s door is UNLOCKED.

2. Insert the key into the ignition switch and then pull it out.

3. Press the Master Door Lock Switch (this would be the switch IN the car) 5 times from Lock to
Unlock.

4. Close the Driver's door then open it.

5. Repeat step 3.

6. Now select the mode by inserting the key into the ignition switch and turning it to the Run or
On position. The programming mode is determined by the amount of times you go from key off to
the key on position and back before pulling the key out.

A. 1 time is the Add mode. This is used only on some models and it allows you to add a remote to
the already existing remotes. The ECU confirms this by locking and unlocking the door locks
automatically after you remove the key.

B. 2 times is the Erase mode which will erase all previously programmed remotes and allow you to
program new ones. The ECU confirms this mode by locking and unlocking the door locks twice
after you remove the key

C. 3 times is the third mode which tells you how many remotes are already programmed to the
ECU. It confirms this locking and unlocking the doorlocks the amount of times applicable to the
remotes coded. If no remotes are programmed then the ECU locks and unlocks the door locks 5
times. The ECU will hold up to 4 remotes at any one time.

7. Press the Lock and Unlock buttons on the remote simultaneously for 1.5 sec and then press either
button by itself for 1 sec.

8. The ECU will perform the Lock/Unlock automatically to confirm that the 1st remote is stored by
the ECU. Repeat step 7 immediately with another remote and continue until all remotes are
registered.

9. Shut the driver’s door and try all remotes.

FOR 2002+
Procedure

1. Make sure all doors and windows are closed.


2. Insert master key into the ignition cylinder.
3. Cycle the ignition cylinder from ON to OFF 5 times.
4. Open and close the driver side door 6 times.
5. Remove the master key and insert the new duplicate key.
6. DO NOT TURN THE IGNITION CYLINDER ON
7. The new key will be registered after 60 seconds.

You might also like