0% found this document useful (0 votes)
24 views

Microsoft Word - Week 1.docx

The document consists of a series of questions and answers related to IoT technologies, covering topics such as Z-Wave communication, IEEE 802.15.4 standards, NFC communication modes, and MQTT QoS levels. Each question is followed by the correct answer and a justification referencing specific lecture slides. The assignment tests knowledge on various IoT protocols, devices, and standards.

Uploaded by

higowa5217
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
24 views

Microsoft Word - Week 1.docx

The document consists of a series of questions and answers related to IoT technologies, covering topics such as Z-Wave communication, IEEE 802.15.4 standards, NFC communication modes, and MQTT QoS levels. Each question is followed by the correct answer and a justification referencing specific lecture slides. The assignment tests knowledge on various IoT protocols, devices, and standards.

Uploaded by

higowa5217
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

ASSIGNMENT - 1

1. Fill in the blank space designated by the question mark.

a. Snubber
b. Repeater
c. Processor
d. Amplifier

Answer: (c)

Justification: Please refer to Slide 2 of Lecture 1 of Week 1

2. What is the maximum data rate of Z-Wave communication technology?


a. 100 kbps
b. 250 kbps
c. 500 kbps
d. 1 Mbps

Correct Answer: (a)

Justification: Please refer to Slide 4 of Lecture 3 of Week 1

3. Which device converts electromagnetic energy into electricity and vice versa?

a. Speaker
b. Antenna
c. Microphone
d. Strain gauge

Answer: (b)
Justification: Please refer to Slide 3 of Lecture 1 of Week 1

4. What does 'Range' indicate in a sensor?

a. The correctness of the output


b. The smallest change in input that can be detected
c. The difference between the standard value and the value produced by the sensor
d. The highest and the lowest value of the physical quantity within which the sensor can
actually sense

Answer: (d)

Justification: Please refer to Slide 8 of Lecture 1 of Week 1

5. Which coding scheme is used by the IEEE 802.15.4 standard for transmitting information?

a. CSS
b. THSS
c. OFDM
d. DSSS

Answer: (d)

Justification: Please refer to Slide 5 of Lecture 2 of Week 1

6. What is the standard transmission range of IEEE 802.15.4?

a. 10 m to 75 m
b. 1 m to 9 m
c. 15 cm to 60 cm
d. 1 cm to 10 km

Answer: (a)

Justification: Please refer to Slide 6 of Lecture 2 of Week 1

7. Which low power radio communication technology was designed as a simpler and cheaper
alternative to Zigbee for small to medium range connectivity?
a. Bluetooth
b. Z-Wave
c. RFID
d. NFC

Answer: (b)

Justification: Please refer to Slide 3 of Lecture 3 of Week 1

8. Which organization has developed the ISA 100.11a standard?

a. Instrument Society of America


b. International Society of Automation
c. International Studies Association
d. International Solar Alliance

Answer: (b)

Justification: Please refer to Slide 8 of Lecture 3 of Week 1

9. What communication modes are supported between two NFC devices?

a. Broadcast-Multicast
b. Master-Slave
c. Active-Active or Active-Passive
d. All of these

Answer: (c)

Justification: Please refer to Slide 21 of Lecture 3 of Week 1

10. Which of the following is/are the drawbacks of proprietary non-IP-based solutions?

a. Limited flexibility to end users


b. Interoperability
c. Limited last-mile connectivity
d. All of these
Answer: (d)

Justification: Please refer to Slide 6 of Lecture 4 of Week 1

11. Which MQTT QoS Level is also known as “at most once” delivery?

a. QoS 0
b. QoS 1
c. QoS 2
d. None of these

Answer: (a)

Justification: Please refer to Slide 7 of Lecture 5 of Week 1

12. Fill in the blank. In CoRE the IoT client uses ________ for the discovery of IoT devices.

a. Lookup interface
b. Resource Directory
c. Registration Interface
d. None of these

Answer: (a)

Justification: Please refer to Slide 10 of Lecture 4 of Week 1

13. Apart from MQTT, which IoT networking protocol supports the publish/subscribe
framework?

a. XMPP
b. AMQP
c. DDS RTPS
d. All of these

Answer: (d)

Justification: Please refer to Slides 14, 17, and 22 of Lecture 5 of Week 1


14. Which of the following IoT protocols is based on the session layer of the OSI model?

a. MQTT
b. CoAP
c. AMQP
d. DTLS

Answer: (d)

Justification: Please refer to Page 7 of the book Introduction to Industrial Internet of Things and
Industry 4.0 by S Misra, C Roy, and A Mukherjee

15. Which of the following is not a component of RFID?

a. RFID Tag
b. RFID reader
c. Antenna
d. Router

Answer: (d)

Justification: Please refer to Page 141 of the book Introduction to Internet of Things S Misra, A
Mukherjee, and A Roy

You might also like