Scribd
Upload
16 views

GENERAL WORK PERMIT

The document outlines a General Permit to Work for Bawan Al Memar Co, detailing the project name, permit number, work location, and description, along with potential hazards and required personal protective equipment (PPE). It specifies necessary precautions, approval signatures from the supervisor, safety officer, and HSE manager, and notes that the permit is valid for 7 days and will be canceled in emergencies or if safety provisions are not followed. The permit must be closed out with signatures after task completion.

Uploaded by

sanasafety5
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
16 views

GENERAL WORK PERMIT

The document outlines a General Permit to Work for Bawan Al Memar Co, detailing the project name, permit number, work location, and description, along with potential hazards and required personal protective equipment (PPE). It specifies necessary precautions, approval signatures from the supervisor, safety officer, and HSE manager, and notes that the permit is valid for 7 days and will be canceled in emergencies or if safety provisions are not followed. The permit must be closed out with signatures after task completion.

Uploaded by

sanasafety5
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

GENERAL PERMIT TO WORK

PROJECT NAME: PERMIT NO:


PACKAGE:

CONTRACT CODE:
CONTRACTOR NAME: BAWAN AL MEMAR CO
ISSUE DATE: EXPIRATION DATE TIME:

WORK LOCATION: DEPARTMENT/ DICIPLINE:

WORK DISCRIPTION: (ANY CHANGE OR ALTERATION OF WORK SPECIFIED


IN THIS PTW WILL REQUIRE CANCELATION OF THIS PERMIT)
POTENTIAL HAZARDS: PPE REQUIREMENTS:
☐Working on center ☐Sharp edges ☐Safety shoes
☐Median ☐Fall hazard ☐Chemical suit
☐Moving parts ☐Flying debris ☐Chemical Goggles
☐toxic corrosive substances ☐Slippery/wet surface ☐Safety Glass
☐flammable material ☐Extreme cold/hot temperature ☐Chemical Gloves
☐spill potential ☐Hit by moving ☐Cotton/ Rubber Gloves
☐Restricted area ☐Droving ☐N95 Mask
☐Toxic Gas ☐Dust mask
☐Manual Lifting ☐Face shield
☐Electrical hazards

REQUIRED PRECOUTIONS RECIEVER ISSUER


YES NO N/A YES NO N/A
➢ Assess all hazardous condition that may occur during work
➢ All equipment in good working condition
➢ Follow all safety procedures while performing the task
➢ All personal are inducted by HSE Dep prior proceeding to
work
➢ Supervisor are knowledgeable for their responsibility to all
his workers
➢ Chemical hazards have been evaluated accordingly
➢ Toolbox talks will be performed at least every once a week
➢ Rams should be discussed to all workers
GENERAL PERMIT TO WORK
PTW APPROVAL NAME/SIGNATURE PTW CLOSE OUT
Name Signature Signature Date closed
SUPERVISOR I will ensure full
compliance of the permit
and will exercise full
supervision of the work.
SAFETY I confirm that all safety
OFFICER requirements of this
permit are in place and
endorsing its approval.
HSE MANAGER I have checked and
approved the precautions
listed above and
authorized
commencement of work

NOTE:

• This permit is automatically cancelled when there is an emergency or change of work other than
the original work plan. A new permit is required prior to the resumption of work.
• This is valid for 7 days
• If the provision of the permit is not followed the permit will be cancelled and the work supervisor
will subject for suspension/ termination from the project.
• The permit shall be closed out by all signatures and handed over to the HSE officer after the
completion of the task/ job.

You might also like