STEP

Elevator Controller System

www.boostindustry.co.th

Europe EN81 NRTL ISO14001 North America ISO9001 China UL Q+3 CNAS-L6430
STEP Elevator Controller Products Introduction

STEP Integrated Controller AS3800-C7000 Controller Cabinet technical support

-Closed-loop vector control. MODEL Name
Power
Elevator Controller Model AS380-C7000
5.5kW-22kW.
Speed 0.4-2.0 m/s
-New no-load sensor startup compensation technology. Max floor Stops up to 64 Stops

-New PWM dead-zone compensation technology. AS380-C7000 Control method

Communication
Full Collecting Control
CAN-Bus series communication
Applicable main engine Gearless PM synchronous pulling machine
-Dynamic PWM carrier modulation technology. * Geared IM asynchronous electric motor
Brake voltage DC110V/AC110V/...........
-Applicable for both synchronous and asynchronous motor. Connector Plug and Pin connector
Elevator type Machine Room and Machine Roomless
-Dual 32-bit embedded microprocessor. Input power 400V:three-phase 340-440,50-60Hz
Installation On the ground and Wall
-CAN-Bus series communication. Controller cabinet dimension (w)420x(h)1184x(d)200 mm.

-Applicable for residential lift,passenger lift,goods lift,etc.

www.boostindustry.co.th
Elevator Control Sysytem Standard Function
No. Description of function No. Description of function No. Description of function
1 Collective Control 21 Service Floor Setting 41 Lower Speed Protection
2 Inspection Operation 22 Inducating Symbols Setting for Every Floor 42 Leveling Switch Fault Protection
3 Self-rescue Operation 23 Attendant Service 43 CAN Communication Fault Protection
4 Testing Mode 24 Independent Mode 44 Safety Edge Protection
5 Clock Control 25 Display 45 Brake Switch Contact Direction
6 Automatic Control for Door-opening time 26 Fire Emergency Return Running 46 Diagnosis of Failure in Self-Teaching of Shaft information
7 Open the Door by Landing Call 27 Automatic Correction of Shaft Information 47 Motor Thermal Protection
8 Pre-close the Door-closing Button 28 Elevator Lock-out 48 Door Switch Fault Protection
9 Open The Door by Door-Opening Button 29 Protection against Door-opening outside Door Zone 49 Protection of Door Switch Off in Running
10 Door Mode Selection 30 Light Curtains Protection for Doors 50 Duplex Mode
11 Next Landing 31 Over-load Protection 51 Leveling Fine-tuning
12 Cancel a Wrong Registration 32 Anti-nuisance at Light-load 52 Door Nudging with Buzzer
13 Clear Registrations before Reversing 33 Reversing Protection 53 Door-opening when Standby at Main Floor
14 Direct Landing 34 Running Time Limiter 54 Floor Blocking within Setting Time Interval
15 By-passing Landing Call When Full-load 35 Fault Protection for Terminal Switch 55 Automatic Inquiry of Landing Call Board
16 Power-off Car Light&Fan when Stand-by 36 Protection Against Terminal Over Travel 56 CAN Communication Interferance Evalutions
17 Auto Homing 37 Contaction detection for Safety Relays and Contactors 57 Evaluation about Encoder Interferance
18 Re-close Door 38 Protection Against Safety Circuit Fault 58 Elevator Ajustment in Car
19 Historical Error Log 39 Master CPU Protecrtion by WDT
Integrated Controller technical support
20 Self-teching of Shaft information 40 Over Speed Protection

Model Rated Rated Rated Rated Matching Controller Cabinet Dimension(mm.)

AS380- Input Power Capacity Input Output Motor Power Elevator Control Sysytem Standard Function
A H W D No. Description of function No. Description of function No. Description of function
C7000 (V) (kVA) (A) (A) (kW)
1 Pre-door-opening(with SM11-A/B Board) 9 Emergency Opeartion for Earthquake 17 Voice Reporting

AT05P5 8.5 13.8 13 5.5 2 Releveling with Door Open(with SM11-A/B Board) 10 Arrival Gong on Car 18 Load Compensation for Starting
3 Fireman Service Operation 11 Arrival Light on Landing 19 Door-opening Holding Button
AT07P5 14 19 18 7.5 4 The Second COP 12 Arrival Gong on Landing 20 Display for Out od Service
5 Rear Door COP 13 Sperated Control of Car Doors(front & rear) 21 Car Call Controlled by IC Card
AT0011 18 28.5 27 11
380 320 1184 420 200 6 COP for the Handicapped 14 VIP Priority Service 22 Landing Call Controlled by IC Card
AT0015 24 36 34 15 7 Group Control(with SM-GC Board) 15 Emergency Landing when Power Failure
8 Community Monitoring 16 Service Floor Controlled by Switch
AT18P5 29 43 41 18.5
AT0022 34 50 48 22
STEP Elevator Controller Products Introduction

STEP Full Serial VVVF Control Cabinet Model MCP-ST/C0100 STEP Group Control Cabinet Model BCP/PO 100

The control functions are achieved by STEP Full Serial Control System. The group control functions are achieved by STEP Full Serial Control System.
Humanized fumctions,i.e. Simplex,Duplex,Group control,Remote monitoring,
Emergency rescue.,are viable to be realized.
Cable cores and cost are reduced efficiently with CAN-Bus Serial communication. Controller Cabinet technical support
More stability and best travel feeling are realized due to excellent VVVF drive system.
Name Elevator Group Controller Model BCP/PO 100
Controller Cabinet technical support Max.number of group
Simple configuration
3-8 Unit Elevator
Only one group control board required and CAB-Bus
Max floor Max elevator 64 floors
Name Elevator Controller Model MCP-ST/C 0100 Peak hour mode Applicable to elevator usage in peak hour of public places such office buildings.
Power 5.5kW-45kW. Communication CAN-bus series communication
Speed 0.4- 4.0 m/s Balanced running mode Optimal elevators allocation to monimize waiting time and reasonable and
Max floor Stops up to 64 Stops * fast elevator response.
Control method Full Collecting Control Idel running mode Even distribution of elevator at designated floor in indle time to minimize the
Communication
Applicable main engine
CAN-bus series communication
Gearless PM synchronous pulling machine
BCP/PO 100 *
Automatic removal of
reaction time of landing call.
Short reaction time of landing call.
* Geared IM asynchronous electric motor reluctant elevator
Brake voltage DC110V/AC110V/...........

www.boostindustry.co.th
Connector Plug and Pin connector
Elevator type Machine Room Destination Dispatch System
Input power 400V:three-phase 340-440,50-60Hz
Installation On the ground
Controller cabinet dimension (w)650x(h)1,450-1,800x(d)375 mm.
MCP-ST/C 0100 Main Controller
Compatible Invertor
STEP SM-01-F5021 Board
STEP AS320 Series Elevator Invertor
Safety Standard GB7588/EN81
Touch Panel Keypad

STEP Roomless Full Serial VVVF Control Cabinet STEP Destination Dispatch System
Elevator Remote Monitoring System Super Effcient Various leading-edge technology applied such as expert
Model MCP-SW/F 0400 system,fuzzy logic,neural network,etc CAN-Bus based,
improve dispatching efficiency greatly.
Joy-Journey By destination dispatching system to guide passengers
The control functions are achieved by STEP Roomless Full Serial Control System and to the assigned lift,it reduces the average waiting time
easier to adjust by adopting CAN-Bus Serial Communication. & long waiting ratio to avoid the crowded lobby and
Humanized fumctions,i.e. Simplex,Duplex,Group control,Remote monitoring, rushing people,which makes them more comfortable.
Emergency rescue.,make elevator operator safer more reliable. Cost-Saving With more effcient dispatching,reducing lift deployment
in group for same traffic capacity requirement.
Energy-Saving Fewer unnecessary stops helps reducing energy

Controller Cabinet technical support consumption in the building.

Support Hybrid & Full DDS Both

Name Elevator Controller Model MCP-SW/F 0400 Multi-Choice for Destination Selecetor
Power 5.5kW-22kW. Multi-Choice for Destination Indicator
Speed 0.4-2.5 m/s
Max floor Stops up to 64 Stops STEP District Monitoring System
Control method Full Collecting Control # Supports star and bus connection.
Communication CAN-bus series communication # 500ms perfect monitoring for 100 units of individual elevator.
Applicable main engine Gearless PM synchronous pulling machine # Real-time fault alarm alert and intelligent trouble shooting.
Brake voltage DC110V/AC110V/........... # Management based on Multi-level authorization which can be set up by
Connector Plug and Pin connector intelligent user software.
Elevator type Machine Roomless # Multiple interface.
Input power 400V:three-phase 340-440,50-60Hz
Installation On the ground and Wall STEP Remote Intelligent Dianosis System
Controller cabinet dimension (w)400x(h)2,100x(d)260 mm. # Only 3 Parameters complete debugging.
Main Controller STEP SM-01-F5021 Board # 2-minute vibration curve.
Compatible Invertor STEP AS320 Series Elevator Invertor # Humanized leveling adjustment.
Safety Standard GB7588/EN81 # Automatically recognize input type(NO/NC)
MCP-SW/F 0400 # Intelligently recognize the display board address.
#Remotely assisnt in controller adjustment.
STEP Elevator Controller Products Introduction

STEP Operation Panel Passenger Elevator. STEP STEP Hall Lanterns Passenger Elevator.
New Design
STEP-FK-531

COP & LOP

Model 130
Operation Panel 130
# Car Operation Panel
for high rise building and
middle building
# Save area of panel. STEP-FK-217
# Save cost and save stock
# Narrow Frame
# Ultra-thin Design STEP-FT-381
STEP-MG-451 STEP-MG-311

STEP-FK-511
STEP-Hall Lanterns
Hall Lanterns Passenger Elevator
Various Type of customized Hall Lanterns,with Long lifespan IEDs.

www.boostindustry.co.th
STEP-XG-451 STEP-BG-451 STEP-ZG-451 STEP-XG-311 STEP-ZG-311

STEP-CEA-130 STEP-LSA-130
STEP-Smart-451 STEP-Silver-311
Operation Panel Passenger Elevator Operation Panel Passenger Elevator
# Car Operation Panel,Landing Operation,Landing Display Panel # Car Operation Panel,Landing Operation,Landing Display Panel
# Narrow Frame # Narrow Frame
# Ultra-thin Design # Ultra-thin and Streamline Design
STEP-FK-451
STEP-FK-212
STEP-CG-451 STEP-CG-311 STEP-FT-371
STEP-FK-431
STEP-CSA-130

STEP-Smart-190 STEP-Smart-401 STEP Display Panel Passenger Elevator.

STEP-SM.04HL16/D(5.7’)

Operation Panel Passenger Elevator Operation Panel Passenger Elevator

# Car Operation Panel,Landing Operation, # Car Operation Panel,Landing Operation, STEP-SM.04HS/L
Landing Display Panel Landing Display Panel STEP-SM.04TL/W(4.3’)
# Faceplate is made from tempered glass,with # With advanced glass drilling technology,
high-temperature colorful glaze printing design is artistic and
# BLACK and WHITE Color type fashionable

STEP-MG-451 STEP-MK-192 STEP-MG-401

STEP-CK-191 STEP-XK-191 STEP-CK-192 STEP-XK-192 STEP-CG-401 XG-401 BG401 ZG401

STEP-SM.04VL16/X(4.3’)

STEP-SM.04VS/12

STEP-SM.04VS/12

STEP-Smart-161
Operation Panel Passenger Elevator
# Car Operation Panel,Landing Operation,Landing Display Panel
# Full-heigh front-wall swinging type convenient and maintenace

STEP-SM.04TL/T(7’)
STEP-SM.04TL/G (8’) STEP-SM.04TL/(H)/(P)(10.4’) STEP-SM.04TL/(L)/(K)(12.1’)

STEP-CK-191 STEP-CK-192 STEP-CG-401