0% found this document useful (0 votes)
2 views

CORE-72020

The document outlines an examination paper for a physics course, consisting of multiple parts with questions related to electronic components and circuits. It includes questions on diodes, transistors, operational amplifiers, and oscillators, requiring students to demonstrate their understanding of these topics. The paper specifies the marks allocation for each section and the requirement to answer a certain number of questions.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
2 views

CORE-72020

The document outlines an examination paper for a physics course, consisting of multiple parts with questions related to electronic components and circuits. It includes questions on diodes, transistors, operational amplifiers, and oscillators, requiring students to demonstrate their understanding of these topics. The paper specifies the marks allocation for each section and the requirement to answer a certain number of questions.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

+3-IIIS-CBCS-Sc.

(H) — (e) The curve between voltage gain and the


Phy (C – 7)
signal frequency of an amplifier is called
———— of the amplifier.
2020 (f) In a certain oscillator, AV = 50. The
Time : As in Programme attenuation of the feedback circuit must be
————.
Full Marks : 60
Part – II
The figures in the right-hand margin indicate marks.
2. Answer any four questions : 3×4 = 12
Answer from all the Parts as directed.
(a) What is basic difference between ordinary

Part – I diode and zener diode ?


(b) What is dark current in a photo-diode ?
1. Answer four questions : 2×4 = 8
(c) Why does a transistor possess low input
(a) The knee voltage of a crystal diode is
resistance and high output resistance ?
approximately equal to ———— potential.
(d) A transistor has ICBO = 48 nA and α = 0.992.
(b) When the light increases, the reverse current
Find ICEO.
in a photo-diode ————.
(e) Why is voltage divider bias the most widely
(c) If the value of α is 0.9, then value of β for a used method ?
transistor is ————. (f) Write the S. I. Unit and dimension of hybrid
(d) In which type of amplifier the collector parameters h12 and h21.
current flows for less than half cycle of A. C. (g) Why is RC coupling employed in the initial
Signal. stages of a multistage amplifier ?

HF – 119/5 ( Turn over ) HF – 119/5 (2) Contd.


Part – III With neat circuit diagram describe the principle,
3. Answer any four questions of the following : construction and working of full wave Bridge
4×4 = 16 Rectifier.
(a) Distinguish between inverting and non-
inveting OP-AMP. 5. With neat circuit diagram describe the

(b) For a given OP-AMP, CMRR = 10 and


4 construction and working of CE mode NPN
4
differential gain is 10 . Find the common transistor.
mode gain of OP-AMP. OR
(c) How does negative voltage feedback With neat circuit diagram of single stage CE
increase the bandwidth of an amplifier ?
amplifier derive expressions for its current,
(d) Write the advantages and disadvantages of
voltage and power gains using hybrid model.
Hartley Oscillator.
(e) Explain hybrid parameters. 6. With neat circuit diagram describe the
(f) The emitter current in a transistor is 4mA. If construction and working of RC – coupled
the leakage current is 6mA and α = 0.98, then amplifier. Also discuss about its disadvantages.
find the collector current.
OR
(g) Explain Active region of operation of a
With neat circuit diagram describe the principle,
transistor.
construction and working of RC – phase shift
Part – IV
oscillator, with expression for frequency of
Answer any three questions : 8×3 = 24
oscillation.
4. Explain barrier potential. Derive an expression
for it for a step junction. 7. (a) Describe practical CA 741 OP-AMP with
OR circuit symbols.

HF – 119/5 (3) ( Turn over ) HF – 119/5 (4) Contd.


(b) Explain CMRR with different mode of
operation.

OR

With neat circuit diagram describe Wein Bridge


Oscillator using OP-AMP. Also find the condition
for sustained oscillation. 6

HF – 119/5 (9,500) ( 5 ) +3-IIIS-CBCS-Sc.(H) —


Phy (C – 7)

You might also like