Scribd
Upload
20 views

TOM Asiignment 1st and 2nd.

The document outlines two assignments for a course on Theory of Machines, covering fundamental concepts and calculations related to mechanisms. Assignment 01 focuses on definitions and applications of various types of links and mechanisms, while Assignment 02 delves into velocity and acceleration in mechanisms with specific problems to solve. Each assignment includes a given date and a submission date.

Uploaded by

bibeswapnil31
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
20 views

TOM Asiignment 1st and 2nd.

The document outlines two assignments for a course on Theory of Machines, covering fundamental concepts and calculations related to mechanisms. Assignment 01 focuses on definitions and applications of various types of links and mechanisms, while Assignment 02 delves into velocity and acceleration in mechanisms with specific problems to solve. Each assignment includes a given date and a submission date.

Uploaded by

bibeswapnil31
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

CO-1

THEORY OF MACHINES – 313313


Assignment No – 01
Unit - I. Chap – 01. Fundamentals & Types Of Mechanisms.
1. Define rigid link & Flexible link with Example

2. Define Sliding pair with one example

3. Define completely constrain motion

4. Define kinematic chain

5. State any four Application of Quick Return Mechanism

6. Sketch & explain the working of ‘scotch yoke mechanism

7. Difference between machine & structure

8. List type of constrain motion with example

9. Define Lower pair & Higher Pair with example

10. Sketch & explain Ternary joint & Quaternary Joint.

Assignment Given Date - 18/01/2025

Assignment Submission Date – 21/01/2025

***
CO-2
THEORY OF MACHINES – 313313
Assignment No – 02
Unit - II. Chap – 02. Velocity & Acceleration in Mechanisms.
1. Define linear velocity & Angular velocity
2. Define relative velocity
3. In four bar chain ABCD, AD is fixed & is 150mm long the crank AB is 40mm long &
rotate at 120 RPM Clockwise. While link CD=80mm oscillate about DBC & AD are
equal length. Find the angular velocity of link CD when angle BAD=50 Degree.
4. Define angular acceleration & linear acceleration
5. Define i) linear acceleration ii) Relative Acceleration iii) Angular Acceleration
6. For a single slider crank mechanism state the formulae to calculate by analytical method
i) Displacement Of Slider ii) Velocity Of Slider iii) Acceleration Of Slider iv)
Annular Velocity of Connecting Rod v) Angular Acceleration of Connecting
Rod.
7. The mass of the reciprocating part of horizontal ic engine is 2 kg. The length of crank id
6cm and connecting rod of 24cm long when crank has travel 30degree from IDC Find
acceleration force Pf if engine run at 600 rpm
8. In a slider crank mechanisms crank AB=20MM.&Connecting rod BC=80MM, Crank AB
rotate with uniform Speed of 1000rpm in anticlockwise direction find i) Angular velocity
of connecting rod BC ii) Velocity o slide C, when Crank AB make an angle 60degree
with horizontal, draw the configuration diagram also use analytical method.
9. Explain the klein’s construction to determine acceleration of a link an I.C Engine
mechanisms
10. The crank and connecting rod of reciprocating engine are 200mm & 700mm respectively,
the crank rotating an clockwise directions at 120rad/sec draw klein constructions and find
velocity and angular acceleration of the piston

Assignment Given Date - 05/02/2025

Assignment Submission Date – 10/02/2025

***

You might also like