Scribd
Upload
23 views

Network Analysis Jan 2023

This document is an examination paper for the B. Tech II Semester in Network Analysis, covering various topics across five units. Students are required to answer any five questions, with each question carrying equal marks. The exam includes questions on circuit analysis, network topology, steady state and transient response, alternating quantities, resonance, and two-port networks.

Uploaded by

srikanth914
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
23 views

Network Analysis Jan 2023

This document is an examination paper for the B. Tech II Semester in Network Analysis, covering various topics across five units. Students are required to answer any five questions, with each question carrying equal marks. The exam includes questions on circuit analysis, network topology, steady state and transient response, alternating quantities, resonance, and two-port networks.

Uploaded by

srikanth914
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Code No: R201213 R20 SET - 1

I B. Tech II Semester Supplementary Examinations, January/February - 2023


NETWORK ANALYSIS
(Common to ECE, EIE, ECT)
Time: 3 hours Max. Marks: 70
Answer any FIVE Questions ONE Question from Each Unit
All Questions Carry Equal Marks
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
UNIT-I
1 The power dissipated in the 4Ω resistor is 1W for the following circuit. Find the [14M]
power dissipated in the 3Ω resistor, power delivered by the DC source and the
value of source voltage.

(OR)
2 a) Explain the following terms w.r.t network topology: [7M]
i) Tree and Co-Tree ii) Twigs and Links iii) Incidence matrix and its properties.
b) For the following circuit, find the value of V2 that will cause the voltage across [7M]
20 Ω to be zero by using mesh analysis

UNIT-II
3 a) Explain about steady state and transient response of the circuit. [7M]
b) The circuit shown in the figure below consists of resistance, inductance, and [7M]
capacitance in series with a 100 V constant source when the switch is closed at
t = 0. Find the current transient.

(OR)

1 of 3

|'''|'|'|''|''||'|||
Code No: R201213 R20 SET - 1

4 For the circuit shown below determine the complete solution for the current, when [14M]
the switch is closed at t = 0.

UNIT-III
5 a) Explain the following terminologies w.r.t alternating quantities: [7M]
i)Time period and Frequency ii) Phase difference
iii)Average Value and RMS value iv) Form factor and Peak factor
b) A series circuit consisting of a 25 Ω resistor, 64 mH inductor and an 80 µF [7M]
capacitor is connected to a 110-V, 50-Hz single-phase supply. Calculate the
current and voltage across each element and the overall power factor of the
circuit.
(OR)
6 a) If the two coils of self-inductances L1 and L2 are connected in series opposing [7M]
connection with a mutual inductance M then prove that the total inductance is
equal to Leqv = ( L1 + L2 - 2M).
b) Find the voltage drop across the resistance ‘r’ for the network shown below: [7M]

UNIT-IV
7 a) Compare the properties of series and parallel resonance. [4M]
b) Explain why the shape of a resonance curve depends on Q of the coil. [3M]
c) A series RLC circuit consists of a resistance of 1 kΩ, an inductance of 10 mH and [7M]
a capacitance of 100 µF. For a supply voltage of 120 V, determine the following:
(i) resonant frequency, (ii) maximum current in the circuit,
(iii) Q factor of the circuit and (iv) half-power frequencies.
(OR)
8 Find the current I in the following circuit using Superposition theorem: [14M]

2 of 3

|'''|'|'|''|''||'|||
R20 SET - 1
Code No: R201213

UNIT-V
9 a) Establish relationship between impedance and admittance matrix of a two-port [7M]
network with required explanation.
b) For the given circuit, find A, B, C and D parameters. [7M]

(OR)
10 a) Explain the conditions that need to be satisfied for making the 2 two port networks [7M]
to be connected in series and parallel.

b) Determine Y - parameters for the network shown and also find whether the [7M]
network is symmetrical and reciprocal.

*****

3 of 3

|'''|'|'|''|''||'|||

You might also like