MANUAL

INEAR MONITOR
WIRELESS SYSTEM
 CAUTION This Class B digital apparatus complies with Canadian
ICES-003.
RISK OF ELECTRIC SHOCK
DO NOT OPEN IC Caution: RSS-Gen Issue 4 December "&"CNR-Gen 4e
Décembre:
WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC This device contains licence-exempt transmitter(s)/receiv-
SHOCK: DO NOT REMOVE SCREWS. er(s) that comply with Innovation, Science and Economic
NO USER-SERVICEABLE PARTSINSIDE. Development Canada’s licence-exempt RSS(s). Operation
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. is subject to the following two conditions:
1. This device may not cause interference.
WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC 2. This device must accept any interference, including
SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR interference that may cause undesired operation of the
MOISTURE. device.

L’émetteur/récepteur exempt de licence contenu dans le

présent appareil est conforme aux CNR d’Innovation,
CERTIFICATION Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L’exploitation est
210-135155 autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
Radio Approvals: FCC Part 15.249, FCC Part 15 B, RSS-210 2. L’appareil doit accepter tout brouillage radioélectrique
(Canada), EN 300 440 (Europe), EN 301.489 (Europe), MIC subi, même si le brouillage est susceptible d’en
Notice No.88 Appendix No.43(Japan) compromettre le fonctionnement.
01
 FCC CERTIFICATION

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. reasonable protection against harmful interference in a
OPERATION IS SUBJECT TO THE FOLLOWING TWO residential installation. This equipment generates, uses
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL and can radiate radio frequency energy and, if not
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY installed and used in accordance with the instructions,
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE may cause harmful interference to radio communications.
THAT MAY CAUSE UNDESIRED OPERATION. There is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
WARNING: harmful interference to radio or television reception,
Changes or modifications not expressly approved in which can be determined by turning the equipment off
writing by Xvive may void the users authority to operate and on, the user is encouraged to try to correct the
this equipment. interference by one or more of the following

RF EXPOSURE STATEMENT: MEASURES:

This transmitter must not be co-located or operated in - Reorient or relocate the receiving antenna.
conjunction with any other antenna or transmitter. - Increase the separation between the equipment and
receiver.
NOTE: - Connect the equipment into an outlet on a circuit
This equipment has been tested and found to comply with different from that to which the receiver is connected.
the limits for a Class B digital device, pursuant to part 15 of - Consult the dealer or an experienced radio/TV
the FCC Rules. These limits are designed to provide technician for help.
02
 IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ THESE INSTRUCTIONS IN A SAFE PLACE

WARNING: BEFORE USING YOUR XVIVE U4 MICROPHONE WIRELESS SYSTEM,

CAREFULLY READ THE OPERATING INSTRUCTIONS.

1. Observe all instructions carefully in the U4 set manual. 3. Do not place near heat sources, such as radiators, heat
2. Do not to perform service operations beyond those registers, or appliances which produce heat.
described in the U4 set manual. Services required when 4. Guard against objects or liquids entering the device.
the apparatus has been damaged in any way, such as: Do not use or place unit near water.
• Liquid has been spilled or objects have fallen into the 5. Clean only with a dry cloth.
apparatus 6. Only use attachments/accessories specified by the
• The unit has been exposed to rain or moisture manufacturer.
• The unit does not operate normally or changes in 7. Prolonged listening at high volume levels may cause
performance in a significant way irreparable hearing loss and/or damage. Always be sure
• The unit is dropped or the enclosure is damaged to practice “safe listening.”
03
 WARNING U4 SET PRODUCT INTRODUCTION

LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN U4 person wireless monitoring system provides better
CAUSE PERMANENT HEARING DAMAGE. USE AS LOW sound feedback for stage performers and performance
A VOLUME AS POSSIBLE. quality. As a portable wireless system, you don't need to
set up. Just plug-and-play to quickly build your monitor-
Over exposure to excessive sound levels can damage
ing system.
your ears resulting in permanent noise-induced
hearing loss. Do not use earphones for a long time FEATURES:
and set the volume below 70% or lower. • 2.4Ghz wireless In-ear monitor system
• Solid RF connection over a 90 feet range(actual range
depends on RF signal absorption, reflection and
interference)
PACKAGE DETAILS • Up to 107 dB signal-to-noise ratio provides clear, detailed
audio at any volume.
• High Resolution 24-bit/48kbps audio
U4 Transmitter 1PCS • Broad 20Hz-20KHz frequency response
U4 Receiver 1PCS • Dynamic Rang 107 dB
USB Cable 1PCS • Less than 5ms Latency, Simultaneous broadcasts on 6
channels.
XLR Male to 1/4" TS Male Adapter 1PCS • 5 Hours of battery life ( rechargeable battery for both
Manual 1PCS Transmitter & Receiver )
Bag 1PCS • Provides smooth frequency response with any headphones
• Mono balanced XLR or mono unbalanced TS input
04
 BASIC OPERATION
U4 TRANSMITTER

1 Input: XLR balanced input jack

2 Spring: Circumferential ground spring providing an
1
2 accurate connection to the mating shell
3 Lock: secures transmitter
3
4 Aux/Line mode: Connect to Aux or line out
5 Power switch: switches unit on/off
4 5
6 Channel status LED: indicates selected channel
7 7 Channel switch: selects Channels 1-6
6
8 USB charging port
8
9 9 Power status LED: indicates power status:
Led off = 100% ~ 30%
10 Solid red = 29% ~ 11%
Flickering red = less than 10%
10 Antenna.
05
 BASIC OPERATION
U4 RECEIVER

1 Power switch: switches unit on/off

2 Headphone Output: 3.5mm output
1 2 Connect to earphones or headphones
3 Channel status LED: indicates selected channel
4 Channel switch: selects Channels 1-6
5 Volume control Adjust the volume of headphone output
3 6 RF Status LED:
4
5
ON = Transmitter is on and link is established
6 Flashing = Signal connection interference
7
OFF = Transmitter off or unlinked
7 Power status LED: indicates power status:
8 9
Led off = 100% ~ 30%
Solid red = 29% ~ 11%
Flickering red = less than 10%
8 USB charging port
9 Antenna.
06
 QUICK START

BATTERIES AND CHARGING

U4 provides USB charging cableyou can connect to USB
Charger Adapter or other USB charging devices
Note: Turn off the power switch while charging. Please do
not use U4 when charging, which may reduce battery life.

OFF
ON Connect to
OR
the socket

POWER ON
* Always store U4 at CHARGING TIMES BATTERY LIFE
POWER ON room temperature
0:15 30 min
* When storing the unit,
please check the 0:30 1 hours
battery state regularly 1:00 2 hours
and charge if necessary. 2:30 5 hours
POWER ON
Start the power switch,
the channel indicator
will light up.

Connect
Power
07
 CHANNEL SWITCH
1
PAIR TRANSMITTER AND RECEIVER

2
5

3
4

U4 has six channels.

Use the channel switch button to switch
the channel. Set the Receiver channel
same with Transmitter. The blue Led
signal on the receiver will always be on
when the connection is successful.
CHANNEL SWITCH

SINGLE TRANSMITTER AND

MULTIPLE RECEIVERS

If you want to add more receiver,

just set the receivers to the same
channel as the transmitter.

MAX. 6 CHANNELS

08
 QUICK START

VOLUME ADJUSTING
LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE
PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME
AS POSSIBLE.

ADJUST TRANSMITTER LEVELS

Adjusting Gain and Listening Volume

VOLUME
SWITCH
For the best audio quality, start by adjusting
the levels from the mixer or audio source and
maximizes the signal-to-noise ratio.
<70% Use with mixers or other
Line (+4 dBu) professional audio devices
that send line-level signals.
Use when connecting
Please do not adjust Aux (-10 dBV) consumer audio devices
the volume to more such as portable audio
than 70%. players or computers.

09
 OPERATION

CREATING MONITOR WITH AUX

1. Transmitter connect Mixer Aux send

2. Trun on the Receiver, adjust the volume of the
Receiver, and gradually increase from small to
large to reach the appropriate volume state
3. Adjust mixer each Aux channel output levels
mixer and send the signal to Transmitter
Note: The channel faders on most mixers do not
affect the volume of the Aux sends.

10
 OPERATION

MIAN OUTPUT

CREATING MONITOR WITH XLR

1. Transmitter connect Mixer output or other XLR output

2. Trun on the Receiver, adjust the volume of the Receiver,
and gradually increase from small to large to reach the
appropriate volume state
3 Adjust mixer each channel faders output levelsmixer
and send the signal to Transmitter

11
 OPERATION

CHANNEL 1

MULTIPLE TRANSMITTER
AND MULTIPLE RECEIVERS

When performers have different

monitoring needs, they can set
up multiple transmitters. If the
receiver is set to the channel
corresponding to the transmit-
ter, the audio can be received.
Or creat mute rehearsal system.

CHANNEL 2

12
 2.4 GHz SPECTRUM OVERVIEW AND INTERFERENCE

U4 operates within the 2.4GHz ISM band which is utilized 2.4Ghz Frequency Tables
by Wi-Fi, Bluetooth, and other wireless devices. 2.4GHz is
an open band and, as such, does not require a license to CHANNEL 1 2402MHz, 2480MHz, 2482MHz
be used worldwide. CHANNEL 2 2408MHz, 2472MHz, 2474MHz
CHANNEL 3 2416MHz, 2464MHz, 2466MHz
Tips and Methods to Improve Wireless System Performance
1) Keep more than 3 meteres distance between Receiver CHANNEL 4 2434MHz, 2440MHz, 2442MHz
unit and other WiFi transmitters such as routers.
CHANNEL 5 2427MHz, 2448MHz, 2450MHz
2) Change channels to avoid interference with other WiFi
products. CHANNEL 6 2422MHz, 2456MHz, 2458MHz
3) In case of environmental interference from other WiFi
systems, shorten the distance between the receiver * U2 1~4 channels are the same as U3/U3C/U4 1~4 channels,
and transmitter units. U2, U3/U3C and U4 use in sametime max is 6 sets.

13
 TROUBLESHOOTING

ISSUE SOLUTION
• Check that the U4 Receiver's RF LED is lit.
• Check whether the device has a signal sent to the transmitter
• Check that the power switch is turned on for both the Transmitter and
No Sound the Receiver.
• Ensure that the U4 Transmitter and Receiver are on the same channel.
• The Receiver can be paired with one Transmitter at a time
• Check the Line/Aux setting at the transmitter and verify that the meter is not
reaching the overload
Distorted Audio • Check Levels going in and out of the mixer. Verify that no distortion occurs in
each audio signal.
• Check receiver headphone output Volume level
Low audio output at the receiver • Check Transmitter mode Line/Aux.
• Check Check whether the device has enough signals level to the transmitter.
Signal instability: RF LED flickering • See, “Tips and methods to improve wireless system performance page 13

Unable to switch the channel • The channel switch locks after 15 seconds. Double-click the channel button
to unlock and reset.
Multiple connect • Use one transmitter can connect with more than 2 receivers.
14
 SPECIFICATIONS

U4 WIRELESS INEAR MONITOR SYSTEM

Tuning Bandwidth 2400 – 2483.5MHz

Working Range Up to 90ft Actual Range Depends On Rf Signal Absorption,

Reflection And Interference.
Audio Frequency Response 20Hz – 20KHz(-3dB).
Dynamic Range & Signal-To-Noise Ratio 107dB
Battery Life 5 Hours of battery life
RF Sensitivity -88dBm
Total Harmonic distortion 0.2%
RF Output Power 10 mW E.I.R.P. max
Operating Temperature Range -18℃ to 57℃. Battery Characteristics May Limit This Range.
Channel Count Up To 6 Channels
Latency Less than 5ms Latency
High Resolution audio 24-bit/48Kbps

15
 U4 TRANSMITTER U4 RECEIVER

Dimensions 30 X 28 X 100 mm 47 X 41 X 60 mm
Weight 90g 118g
Housing Molded plastic and cast metal Molded plastic and cast metal
Battery 3.7V Rechargeable Li-ion, 860mAh 3.7V Rechargeable Li-ion, 1200mAh
Impedance Input 47kΩ1KHz 6-600Ω
Audio input Connector Balanced XLR Male input
Audio output Connector 3.5mm stereo output
Aux mode: -10dBV | Max. +12.2dBu
Mode
Line mode: +4dBu | Max. +22dBu
Battery life Up to 5 Hours Up to 5 Hours
Antennal Impedance 50Ω 50Ω
ANTENNA Type 1/4 Wave Sleeve Dipole, Non-removable 1/4 Wave Sleeve Dipole, Non-removable
Number Of Antenna 1 2

16
 U4 SERIES

U4 SET U4R2

1 Transmitter 1 Receiver 1 Transmitter 2 Receiver

U4 standard set to create personal U4R2 set to create small monitoring system
Monitoring system Or backup receiver

17
 WIRELESS INEAR MONITOR SYSTEM

U4R4 U4T

1 Transmitter 4 Receiver 1 Transmitter

U4R4 set to create performance monitoring system
Or mute rehearsal system

Transmitter only, you need to purchase

Additional receivers for use

U4R

1 RECEIVER

Receiver only, you need

To purchase additional
Transmitter for use

18
 PATENT PENDING
2nd floor, Building 12, Xicheng Industrial Area, Xixiang Town,
Baoan District, Shenzhen Guangdong China. 518101
E-mail: [email protected]

210-135155