GUARANTEED CHARACTERISTICS OF XLPE INSULATED MEDIUM VOLTAGE CABLE
1x50/16mm² N2XSY 18/30(36)kV
GENERAL
• Producer : VATAN KABLO / TURKEY
• Cable Code : N2XSY
• Applied Standards : TS IEC 60502-2
• Voltage Rate (U0) (kV) : 18
• Voltage Rate (U) (kV) : 30
• Max Operating Voltage (Um) (kV) : 36
STRUCTUAL PROPERTIES
CONDUCTOR
• Material : Copper
• Cross-Section Area (mm²) : 50
• Minimum number of wires in conductor (№) : 6
• Type of Stranding : CIRCULAR COMPACTED
• Outer Diameter (Approx.) (mm) : 8,20
• Number of Core (№) : 1
CONDUCTOR SCREEN
• Material : Semiconductive XLPE
• Nominal Thickness (mm) : 0,50
• Minimum Thickness (mm) : 0,30
• Outer Diameter (Approx.) (mm) : 9,20
INSULATION
• Material : XLPE
• Nominal Thickness (mm) : 8,00
• Minimum Thickness (mm) : 7,10
• Outer Diameter (Approx.) (mm) : 25,20
INSULATION SCREEN
• Material : Semiconductive XLPE
• Nominal Thickness (mm) : 0,50
• Minimum Thickness (mm) : 0,30
• Outer Diameter (Approx.) (mm) : 26,20
• Semi Conductive Tape : S.C. Tape
• Tape Thickness (mm) : 0,20
METALLIC SCREEN
• Material : Copper
• Type : Wire&Tape
• Number & Diameter of Wires (№ x mm) : 46x0,67 or 30x0,80
• Thickness & Width of Copper Tape (mm x mm) : 0,10x10
• Tape for Protection (mm) : 0,05
• Outer Diameter (Approx.) (mm) : 28,40
• Total Cross Section Area (mm²) : 16,00
(FORM NO: RG.F025 11/09 REV:8) Page 1 / 4
GUARANTEED CHARACTERISTICS OF XLPE INSULATED MEDIUM VOLTAGE CABLE
1x50/16mm² N2XSY 18/30(36)kV
INNER SHEATH (Filler+Bedding)
• Filler Material : -
• Bedding Material : -
• Nominal Thickness (mm) : -
• Minimum Thickness (mm) : -
METALLIC ARMOUR
• Material : -
• Number & Diameter of Wires (№ x mm) : -
• Thickness of Steel Tape (mm) : -
• Width of Steel Tape (mm) : -
• Binding Ratio (%) : -
OUTER SHEATH
• Material : PVC
• Colour : Red or Black
• Nominal Thickness (mm) : 2,00
• Minimum Thickness (mm) : 1,40
ELECTRICAL PROPERTIES
• Test Voltage of 5 Minute Duration (kV-rms) : 63
• Impulse Test Voltage (kV-Peak) : 170
• Continuous Current Carrying Capacity in Air at 30 °C (A) : 238 *^* / 279 ***
• Continuous Current Carrying Capacity in Ground at 20 °C (A) : 223 *^* / 250 ***
• Continuous Current Carrying Capacity in Duct (A) : 211 *^* / 230 ***
*^* Trefoil Formation, *** Flat Formation
Above current carrying capacities are calculated at the following laying conditions:
- Ambient Temperature of Air 30 °C
- Soil Temperature 20 °C
- Depth of Laying 0,8 m
- Thermal Resistivity of Soil 1,5 K m /W
• Inductance (mH/km) : 0,469 *^* / 0,516 ***
• Capacitance (μF/km) : 0,138
• Insulation Resistance (MΩ.km) : 160,37
• Dielectric Losses (at 90 °C, 3 phases) (W/km) : 168,560
• Max. Continuous Conductor Temperature (°C) : 90
• Max. Conductor Temperature at Short Circuit Condition (°C) : 250 (5 s max. duration)
(FORM NO: RG.F025 11/09 REV:8) Page 2 / 4
GUARANTEED CHARACTERISTICS OF XLPE INSULATED MEDIUM VOLTAGE CABLE
1x50/16mm² N2XSY 18/30(36)kV
Maximum Short-Circuit Current
(Start Temperature 90 °C, End Temperature 250 °C)
• Duration of 5 seconds (kA) : 3,20
• Duration of 1 seconds (kA) : 7,15
• Duration of 0,5 seconds (kA) : 10,11
Maximum Short-Circuit Current at Metallic Screen
(Start Temperature 80 °C, End Temperature 200 °C)
• Duration of 1 seconds (kA) : 2,05
• Duration of 0,5 seconds (kA) : 2,90
Dielectric Loss Factor
• At 90 °C (Maximum Operating Temperature) : 40x10^-4
• Conductor Resistance at 20 °C (Ω/km) : 0,3870
• Conductor Resistance at 90 °C (Ω/km) : 0,4935
• Charging Current (A/km) : 0,78
• Partial Discharge (at 2 U0) (pC) : 5,00
OTHER PROPERTIES
• Outer Diameter of Cable (Approx.) (mm) : 32,50
• Minimum Bending Radius (During Installation) (mm) : 488
• Lowest Laying Temperature (°C) : -5,00
• Weight of Cable (Approx.) (kg/km) : 1355
• Weight of Copper (Approx.) (kg/km) : 560
• Weight of Armour (Approx.) (kg/km) : -
Drums
• Type : Wooden
• Flange (Wheel) Diameter (mm) : 1700
• Barrel Diameter (mm) : 850
• Barrel Length (mm) : 900
• Length of Cable (m) : 1000
• Gross Weight (kg) : 1595
"Note:Vatan Kablo may change design constructions provided it comply with original standards."
DATE
18.04.2024
(FORM NO: RG.F025 11/09 REV:8) Page 3 / 4
GUARANTEED CHARACTERISTICS OF XLPE INSULATED MEDIUM VOLTAGE CABLE
1x50/16mm² N2XSY 18/30(36)kV
XLPE Insulated Single-Core Cable with Copper Conductor
DESCRIPTION
Application
They are used in cable ducts, outdoor and indoor installations, under ground where the short circuit levels are
high such as urban and industrial areas fed by electrical energy.
Design
1. Copper Conductor
2. Conductor Screen
3. XLPE Insulation
4. Insulation Screen
5. Semi-Conductive Tape
6. Copper Wire and Tape Screen
7. Polyester Tape
8. PVC Outer Sheath
Saray Mah. Ö. Faik Atakan Cad. No:3 Yılmaz Plaza 34768 Ümraniye / İSTANBUL - TÜRKİYE
Tel: +90 212 210 33 31 Fax: +90 212 210 33 43 http://www.vatan.com.tr
(FORM NO: RG.F025 11/09 REV:8) Page 4 / 4
