project 2
project 2
A Project Report on
“ AUTOMATIC SOLAR TRACKER CIRCUIT ”
Submitted in partial fulfilment of the requirements for award of the degree
Bachelor of Technology
in
Electronics & Communication Engineering
from
MAULANA ABUL KALAM AZAD UNIVERSITY OF TECHNOLOGY
By
NAME OF THE CANDIDATE
I/We hereby declare that the project report entitled as AUTOMATIC SOLAR
TRACKER CIRCUIT is a bona fide record of the systematic work done by us under the
guidance of , Department of Electronics and
Communication Engineering. Mallabhum Institute of Technology, Bishnupur, India and that
no part there of has been presented for the award of any other degree.
2|Page
CERTIFICATE
This is to certify that the project proposal entitled ‘ AUTOMATIC SOLAR TRACKER
CIRCUIT, by Rahul Das , Khokan Garai ,Kajijul khan , Kaushik Nayak submitted to the
Mallabhum Institute of Technology, Bishnupur affiliated to MAKAUT for the degree of
Bachelor of Technology, is a record of bonafide work, carried out by him in the department
of Electronics and Communication Engineering under my supervision and guidance. I/We
believe that the work fulfils part of the requirements for the award of degree of Bachelor of
Technology. To the best of my knowledge, the matter embodied in the project has not been
submitted to any other University/Institute for the award of any other degree.
---------------------------------- ----------------------------
NAME OF PROJECT GUIDE NAME OF HOD / IN-CHARGE
Assistant Professor Head of the Dept.
Department of ECE Department of ECE
3|Page
DEPARTMENT OF ELECTRONICS AND COMMUNICATIONENGINEERING
BISHNUPUR, BANKURA-722122
WEST BENGAL
ACKNOWLEDGEMENT
I/We take this opportunity to express our sincere gratitude to my/our project guide, NAME
OF PROJECT GUIDE for his noble involvement and valuable guidance during the project
work. I/We are indebted to them for their kind help and timely encouragement in making this
project work professionally stimulating and professionally satisfying.
I/We would also like to thank that the other faculty members of ECE Department and
our H.O.D NAME OF HOD for his continuous support and encouragement during the
work.
NAME SIGNATURE
4|Page
CONTENTS
Contents 5
Abstract 7
CHAPTER 1
INTRODUCTION
1.1 Motivation 8
CHAPTER 2
SYSTEM COMPONENTS
2.1 Introduction 12
2.2.2 Battery 17
2.2.3 Daynamo 19
2.2.5 Diode 21
2.2.7 Resistor 26
2.2.8 Wire 27
5|Page
2.2.10 Charge Controler 30
2.4 Conclusion 36
CHAPTER-3
3.1 Advantages 37
3.2 Disadvantages 38
References 40
6|Page
ABSTRACT
Write the abstract here.
Follow Times New Roman 12 font size and line spacing of 1.5
7|Page
CHAPTER 1
INTRODUCTION
8|Page
PROJECT REPORT OBJECTIVES:
9|Page
ORGANISATION OF PROJECT REPORT:
10 | P a g e
CHAPTER 2
SYSTEM COMPONENTS
2.1 INTRODUCTION:
11 | P a g e
2.2 COMPONENTS USED:
12 | P a g e
2.3 CIRCUIT DIAGRAMS :-
13 | P a g e
Working Principle
14 | P a g e
2.4 CONCLUSION:
15 | P a g e
CHAPTER-3
16 | P a g e
3.2 FUTURE WORK:
17 | P a g e
REFERENCES
1. A.A.M. Eltaieb, Z.J. Min, “Low Cost Water Level Control System”, International
Journal Of Science And Research, Vol. 4, No. 6, Dec. 2015
3. Dietz, P., Yerazunis W., & Leigh, D. (2003). Very Low-Cost Sensing Devices.
India: Chand & Company.
5. Hicks, F., Tyler, G.; & Edwards, T.W. (1971), ‘Pump Application Engineering’.
McGraw-Hill Book Company, New York.
18 | P a g e