501

Pressure transmitter
Relative 0 – 40 bar
Absolute 2,5 – 16 bar

HUBA-REGISTERED TRADE MARK

EDITION 07/2004
 Load cycle
< 50 Hz

Dynamic response

Suitable for static and dynamic

measurements.
Response time < 5 ms.

Pressure connections
Inside thread G 1/4
Outside thread G 1/4
DIN 3852 form E

Weight
Inside thread 50 grams
EDITION 07/2004 Outside thread 70 grams

Installation arrangement
Unrestricted.
Technical overview Legend to cross-section drawing
The pressure transmitter of type se- 1 Connection Fitting Signal Power supply
ries 501 with proved ceramic tech- 2 Seals
nology, features calibrated and am- 3 Ceramic element •0 – 5V 11 – 33 VDC
plified sensor signals which are avai- 4 Hybrid electronics 3-wire cable
lable as standardized current out- 5 Connector DIN 43650
puts. •1 – 6V 11 – 33 VDC
Pressure ranges 3-wire cable
Various application-specific pres- Relative pressure/Gage
sure and electrical connections can •0 – 10 V 18 – 33 VDC
(measurement of pressure relative
be provided. 3-wire cable
to ambient pressure).
Absolute pressure. •4 – 20 mA 11 – 33 VDC
Overload 2-wire cable

2x measuring range (fs) • 10 – 90% 4.5 – 6.0 VDC

3-wire cable
Rupture pressure ratiometric
3x measuring range (fs) • Short circuit-proof and protected
(0 – 40 bar max. 90 bar) against polarity reversal. Each
Accuracy connection against other with max.
+/– supply voltage.
Total of linearity, hysteresis and
repeatability Load
< +/– 0.5 % fs
Adjustment accuracy zero point and
0 –5 V > 10 kOhm/<100 nF
full scale (repeatable)
1 –6 V > 10 kOhm/<100 nF
0 –5 V ± 50 mV 0 – 10 V > 10 kOhm/<100 nF
1 –6 V ± 50 mV
0 – 10 V ± 100 mV supply voltage - 11 V
4 – 20 mA < [Ohm]
4 – 20 mA ± 0.16 mA 0.02 A

10 – 90 % ± 1%
10– 90% > 10 kOhm/<100 nF
Housing material
Cover Pa 6 Current consumption
With max. signal output:
Materials in contact with the medium
0 – 5 V < 2 mA
Ceramic/Stainless steel 1.4305
The distinct advantages 1 – 6 V < 2 mA
(AISI 303)
0 – 10 V < 3 mA
• Compact construction Sealing materials:
4 – 20mA < 20 mA
optionally FPM, EPDM, NBR, sili-
• Automated manufacture in large 10 – 90% < 2 mA
cone, according to order code se-
quantities for ideal price/perfor-
lection table. Electrical connections/protection class
mance ratio
• Robust ceramic sensor Temperature influences Cable 1.5 meters, IP 65
technology Medium and ambient temperature Connector DIN 43650-A, IP 65
• High resistance to extreme –15 °C to + 80 °C Connector industrial standard, IP 65
temperatures TC zero point 2.5 to 40 bar
Calibration by customer
• No mechanical aging < +/– 0.04 % fs/K
TC sensitivity Calibrated in the factory
• No mechanical creepage typically < +/– 0.015 % fs/K
 A – Inside thread
G 1/4
B – Outside thread
G 1/4
D – Storage version
cover black
A B C D
E – Female connector
DIN 43650-A
F – Female connector
industrial standard
G – Electrical connec-

Versions
tion with PG 7
H – Connector M12x1
E F G H (on request)

Order code selection table EDITION 01/2004 501 . X X X X X X X X X X

Relative pressure / Gage 9

Absolute pressure 8

Pressure ranges1 (bar) 0... + 2.5 1 4

0... + 4 1 5
0... + 6 1 7
0... + 10 3 0
0... + 16 3 1
0... + 25 9 3 2
0... + 40 9 3 3

Full scale signal at that pressure

Sealing materials2 FPM Fluoro-elastomer 0

EPDM Ethylene propylene 1
NBR Nitrile butadiene 2
MVQ Silicone polymer 3

Calibration Factory calibrated 0

Outputs and 0– 5 V 11.0 – 33.0 VDC 3-wire cable 1

1– 6 V 11.0 – 33.0 VDC 3-wire cable 6
0 –10 V 18.0 – 33.0 VDC 3-wire cable 2
4 –20 mA 11.0 – 33.0 VDC 2-wire cable 3
ratiometric (10-90%) 4.5 – 6.0 VDC 3-wire cable 4

power supply
Electrical connections3 Cable, 1.5 meters (protection standard IP 65) 0
Connector DIN 43650-A (protection standard IP 65) 1
Connector industrial standard (protection standard IP 65) 2

Pressure connections4 Inside thread G 1/4 with O-ring seal 1

Outside thread G 1/4 sealed at back, DIN 3852 form E 4

Housing materials Stainless steel 1

Stainless steel with pressure tip orifice 2

Pressure range Indicate W and mention range on order W

variation

Accessories Female connector DIN 43650-A with seal

(IP 65 when installed and latched) 1 0 3 5 1 0

Female connector (industrial standard) with seal

(IP 65 when installed and latched) 1 0 4 2 4 4

Packaging Mention on order: • single packaging • multiple packaging (25 pcs)

• single packaging with • multiple packaging (25 pcs)

DIN-connector DIN-connector order-no 103510 or
order-no 103510 or Connector industrial standard
Connector industrial standard order-no 104244
order-no 104244 enclosed separatly

Storage versions according separate specification.

1 Other pressure ranges on request.
2 According to ISO standard R 1629, other sealing materials on request.
3 Without female connector.
4 Other materials or connections on request.
Dimensions in mm / electrical connections
EDITION 07/2004

Electromagnetic compatibility:
CE conformity to EC directive 89/336 EEC (EMC) by application of harmonized standards EN 61000-6-1and EN 61000-6-3.

Type of interference/Interference susceptibility Test standard Effects

Electrostatic discharge ESD EN 61000-4-2 No failure
8 kV air, 4 kV contact except ratiometric types
High-frequency electromagnetic EN 6100-4-3 No effect
radiation (HF) 3 V/m, 80...1000 MHz up to 3 V/m
Conducted HF interference EN 61000-4-6 No effect
3 V, 0.15 ... 80 MHz
Fast transients EN 61000-4-4 No effect
Technical data subject to change.

(burst) 1 kV
Surge EN-61000-4-5 No test
max. tolerable cable length 10 m
Magnetic fields EN 61000-4-8 No effect
30 A/m, 50 Hz
Type of interference/Emitted interference Test standard Effects
EN 55022 (CISPR 22)
Conducted interference 0.15...30 MHz No effect
Radiation from housing 30...1000 MHz, 10 meters No effect

Internet: www.hubacontrol.com
Huba Control Switzerland Huba Control United Kingdom Huba Control France Agent for:
Headquarters Unit 3 Network Point e-mail: [email protected]
Industriestrasse 17 Range Road Huba Control Germany
CH-5436 Würenlos GB-Witney Oxfordshire OX29 0YD e-mail: [email protected]
Phone ++41 (0) 56 436 82 00 Phone 01 993 776 667 Huba Control Netherlands
Fax ++41 (0) 56 436 82 82 Fax 01 993 776 671 e-mail: [email protected]
e-mail: [email protected] e-mail: [email protected]