Scribd
Upload
172 views2 pages

WPS hdpe pipe

wps hdpe pipe

Uploaded by

alifalah01995
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
172 views2 pages

WPS hdpe pipe

wps hdpe pipe

Uploaded by

alifalah01995
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

COMPANY NAME

PQR Procedure Qualification Record


AL-YASRA BAC
Refrance: ISO 21307: Plastic piping systems,DVS 2207-1: Welding of thermoplastics.,ASTM F2620 Page:1-2
Sub-Contractor: Title Project:KIC Karbala Industrial City
Contractor :
Fusion procedure specification No.
Rev.No
Date:
Procedure Qualification Record PQR No.
Rev.No
Date:

Material Spec :Black ISO 4427 HDPE Water supply pipe


Thickness Qualified :
Dia Qualified :
Fusion Equipment :
Procedure according the fusion machine instraction and ISO 21307
T1 Bead
Wall thickness P1 bar T2 (Sec) P2 bar T3 (Sec) T4 (Sec) P3 bar T5 (min)
Hight mm
12-19 mm ≤ 0.2
19-26mm ≤ 0.2
Note:
"This chart should interface with the formula to calculate pressure ,WMS explain all"
Temperature range of 210-230°C
As (Section of welding pip ends) Ac (Total section of cylinders)
IP (Interface pressure) , DP (Drag pressure)
When welding HDPE pipes, the joint must be inspected and tested to ensure it meets the quality
standards required to withstand a hydrostatic pressure test . Page No 2
Subcontracor QC Eng BAC QA/QC Mech Engineer PMC (AL Aklam)

Date: Date: Date:


COMPANY NAME

PQR Procedure Qualification Record


AL-YASRA BAC
Refrance: ISO 21307: Plastic piping systems,DVS 2207-1: Welding of thermoplastics.,ASTM F2620 Page: 2-2
Sub-Contractor: Title Project:KIC Karbala Industrial City
Contractor :
Procedure Qualification Record PQR No. Date:
Rev.No
Material Spec :Black ISO 4427 HDPE Water supply pipe
Thickness Qualified :
Dia Qualified :
Fusion Equipment :
The depth of the bead depression shall not extend
below the pipe surface.

fit-up inspection
Pipe Condtion Gap High-Low Remark
ACC REJ mm ACC REJ mm ACC REJ

Visual Inspection
welding Profile Bead height H mm Bead Width W mm Btween Bead Depth mm
ACC REJ Size ACC REJ Size ACC REJ Depth ACC

Hydro test result


Pressure (Bar) Time Result
Acc With
Pressurization Holding Depressurization ACC REJ
comment

Subcontracor QC Eng BAC QA/QC Mech Engineer PMC (AL Aklam)

Date: Date: Date:

You might also like