Scribd
Upload
13 views

Assignment 01

222

Uploaded by

itxtoolate0
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
13 views

Assignment 01

222

Uploaded by

itxtoolate0
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

University of Central Punjab, 6th Road, Rawalpindi Campus.

CSSS1723: Basic Electronics


(Fall 2023)
A#01
Issue date Due date
Instructor: Engr. Jahania Usman
Saturday Saturday
Dec 14 Dec 21

Name: ____________________________ Roll No: ________________


Signature: _________________________ Section: ________________

Important Notes: 1. This cover must be the first page of the

1. ZERO Tolerance Policy for plagiarism and assignment.

cheating. 2. Submit hand written assignments, only.

2. Violators may receive “F” in the course and/or will 3. Assignments should be done on A4 sized blank

face further strict penalty. white (photocopy) paper (70g).

3. Assignments may carry unequal weights. 4. Multiple pages must be double stapled.

4. No retake or allocation of average marks for 5. No binding (file, transparent, ring binding etc.).

assignments in any case, irrespective of the reason, 6. Assignment must be submitted on or before the

genuine or otherwise. due date listed above. If in class, submit @ class


start.
7. No late assignment accepted after due date/time.

Do not write anything below. 8. Quiz date will be same as submission date.

Checked by
Plagiarism ❑ Yes ❑ No
% Attempted
Total Marks 70
Marks Obtained

Submission Guidelines:

Failure to follow these may VOID your assignment.


Q.01
The references for the voltage and current at the terminal of a circuit element are as shown in Fig.

The numerical values for v and i are 40 V and-1 0 A.


a) Calculate the power at the terminals and state whether the power is being absorbed or delivered by the
element in the box.
b) Given that the current is due to electron flow, state whether the electrons are entering or leaving
terminal 2.
c) Do the electrons gain or lose energy as they pass through the element in the box?

Q.02
The numerical values for the currents and voltages in the circuit in Fig. are given in Table. Find the total
power developed in the circuit.
Q.03
The voltage and current are measured at the terminals of the device illustrated in Fig. a, and the values of
v, and it are tabulated in Fig. b. Construct a circuit model of the device inside the box. Also plot the graph
between v and I for the given values.

Q.04
Find Req for the following circuits.

1) 2)
3) 4)

5)

Q.05

Find the current and power supplied by the 40 V source in the circuit shown in Fig
Q.06

Find Rab in the following circuit. Suppose if a current of 10mA is flowing through Rab, find the
voltage applied V.

Q.07

Find the total Resistance (Req) in the given circuit. Make a new circuit in which a battery of 20 V
is attached to this Req calculated. Find the total Current passing through it. Also find the power
dissipated.

You might also like