Scribd
Upload
19 views3 pages

GVRP Configuration on Huawei

Uploaded by

João Manuel Sebastião
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
19 views3 pages

GVRP Configuration on Huawei

Uploaded by

João Manuel Sebastião
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

GVRP Configuration on Huawei

GVRPis the standard based counterpart of Cisco VTP. In this configuration example, we will
focus on how to configure GVRP on Huawei switches.
For out Huawei GVRP Configuration example, we will use the topology below.
On important reminding. Do not think that there can be a loop on this topology. STP
mechanisms prohibit this.
Let’s start our GVRP Configuration on each device.

You can download thic configuration on Huawei eNSP Labs Page.

Table of Contents
• Huawei-Switch 1 Configuration
• Huawei-Switch 2 Configuration

Huawei-Switch 1 Configuration

Firstly, we will enable GVRP Globally on the switch.

< Huawei-Switch1 > system-view


[Huawei-Switch1] gvrp

Secondly, we will configure the first interface as trunk and we will allow all the VLANs to
pass through this interfaces.

[Huawei-Switch1] interface GigabitEthernet 1/1/1


[Huawei-Switch1-GigabitEthernet1/1/1] port link type trunk
[Huawei-Switch1-GigabitEthernet1/1/1] port trunk allow-pass vlan all

Then, we will enable GVRP on the interface and we will configure its registration type. There
are three types of registration as we talked about before. “Normal”, “Fixed” and
“Forbidden”.

Here we will use “fixed” type.


[Huawei-Switch1-GigabitEthernet1/1/1] gvrp
[Huawei-Switch1-GigabitEthernet1/1/1] gvrp registration fixed
[Huawei-Switch1-GigabitEthernet1/1/1] quit

We will configure the second interface similar.


[Huawei-Switch1] interface GigabitEthernet 1/1/2
[Huawei-Switch1-GigabitEthernet1/1/2] port link type trunk
[Huawei-Switch1-GigabitEthernet1/1/2] port trunk allow-pass vlan all
[Huawei-Switch1-GigabitEthernet1/1/2] gvrp
[Huawei-Switch1-GigabitEthernet1/1/2] gvrp registration fixed

Huawei-Switch 2 Configuration

On Switch 2, we will do the similar configuration of Switch 1.

< Huawei-Switch2 > system-view


[Huawei-Switch2] gvrp
[Huawei-Switch2] interface GigabitEthernet 1/1/1
[Huawei-Switch2-GigabitEthernet1/1/1] port link type trunk
[Huawei-Switch2-GigabitEthernet1/1/1] port trunk allow-pass vlan all
[Huawei-Switch2-GigabitEthernet1/1/1] gvrp
[Huawei-Switch2-GigabitEthernet1/1/1] gvrp registration fixed
[Huawei-Switch2-GigabitEthernet1/1/1] quit

You might also like