Scribd
Upload
10 views1 page

ATC-106 User's Manual

Uploaded by

kumarbinug
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
10 views1 page

ATC-106 User's Manual

Uploaded by

kumarbinug
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Model ATC-106 2.4 Sending Control 3.

0 ATC-106 connecting other RS-485 device


RS-232 to RS-485 Interface Converter
ATC-106 does not need RTS to control the RS-485 driver. ATC-106 RS-485 device
User's Manual
The RS-485 driver is automatically enabled during each DB-9 Male
spacing state of SD line (also called TD) on the RS-232 side. PIN2(485-)----------------------- 485-
The ATC-106 has an internal connection to prevent data PIN7(485+)-----------------------485+
transmitted from the RS-232 port from being echoed back to
the RS-232 port. The ATC-106 is used as a two wire (half
duplex) RS-485 Converter.

1.0 General Description


2.5 Operating Distance
The ATC-106 is a 2 channel non-power SD Control RS-232
Data Rate (KBPS): 19.2 9.6 4.8 2.4
to RS-485 interface converter. ATC-106 can convert the TD
Maximum Distance (feet): 4,000 6,000 8,000 10,000 (using
and RD signals of RS-232 into balanced half-duplex RS-
24 AWG wire)
485 signals.
2.0 Specifications
2.6 Power
2.1 Interface
ATC-106 is powered from the RS-232 data TD or
Conforms to EIA RS-232 and RS-485 standards
hand-shake lines. It will try to get its power from RTS or DTR
2.2 Connectors and signals
(at least +5.5V or -5.5V in the quiescent state). If there are
The ATC-106 has a DB-9 female connector on the RS-232
no RS-232 control signals (DTR or RTS) available. ATC-106
side and DB-9 male connector or a terminal block connector
will get power from the data input TD pin (at least -5.5V in
on the RS-485 side.
the quiescent state). For this kind of power stealing devices ,
RS-232 Side:
the sufficient power is needed to operate the device. In
Connector: DB-9 Female.
some case maybe no handshake lines are available and the
Signals: Use Pins 3 (RD) and pin 2(TD also called SD)
TD can not drive ATC-106, then an external 5VDC/40mA
Pins 7 (RTS) and 8 (CTS) are tied together Pins 4 (DTR), 6
power supply can be connected to two terminals on the
(DSR), and 1 (CD) are tied together.
RS-485 connector between terminals +5VDC and GND .
RS-485 Side: Connector: DB-9 male connector or
4 position terminal block -- 485+.485-.+5V.GND .
2.7 Dimensions : 88mmx33mmx17mm

2.3 Data Rate : 300 to 115.2 KBPS, up to 4,000 feet at


2.8 Environment : -20° to 70° C, 5% to 95% relative
19,200 BPS.
humidity
2.9 Connection Diagram

You might also like