HITACHI SH72533 JTAG BED430_431 RENAULT
1 HITACHI SH72533 JTAG BED430/431 RENAULT
1.1 PLUGIN 1692
https://ecu.design
HITACHI SH72533 JTAG BED430_431 RENAULT
https://ecu.design
HITACHI SH72533 JTAG BED430_431 RENAULT
https://ecu.design
HITACHI SH72533 JTAG BED430_431 RENAULT
1.2 DIRECT CONNECTION
In order to connect to the ECU use the cable F32GN037C/D .
Make sure that the POWER led (red) on NEW TRASDATA is ON.
WIRE COLOUR DESCRIPTION
Red +12 V
Orange VKEY
Black GND
Yellow KLINE
Green CAN L
White CAN H
Grey BOOT
Blue CNF1
Purple - Grey VPP
Brown RESET
1.3 ECU CONNECTOR
https://ecu.design
HITACHI SH72533 JTAG BED430_431 RENAULT
1.4 LOOSE WIRES CONNECTION J-TAG
It is necessary to use the cable F34NTF53 for reading and writing.
PIN WIRE COLOUR
11 NOT USED
12 NOT USED
13 NOT USED
14 NOT USED
15 NOT USED
16 BLUE
17 PURPLE
18 GREY
19 WHITE
20 BLACK
21 BROWN
22 RED
23 ORANGE
24 YELLOW
25 NOT USED
26 NOT USED
ATTENTION
Connect the wires on the pads avoiding any short circuits.
https://ecu.design
HITACHI SH72533 JTAG BED430_431 RENAULT
ATTENTION
In order to activate the J-TAG port it is necessary to perform 3 LINK jumpers as in the picture below.
The ECU can be reinstalled in the vehicle without removing the jumpers.
https://ecu.design
