Scribd
Upload
96 views

Jotun Onboard Maintenance Quick Guide

Uploaded by

Osama Salama
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
96 views

Jotun Onboard Maintenance Quick Guide

Uploaded by

Osama Salama
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ONBOARD MAINTENANCE QUICK GUIDE

1 SURFACE PREPARATION 2 PAINT PREPARATION 3 PAINT APPLICATION

For one component paint, be sure to


Clean all surfaces using water soluble
stir the paint using a mechanical mixer For larger jobs, we recommend to use a spray
detergent and high pressure fresh water.
for minimum two minutes. gun. Check equipment prior to application.

For two component paint, check that you have


Remove rust manually or mechanically
the correct component A and B. Stir both compo- Use paint brush for difficult to reach areas and for
by use of power tools. Avoid smooth B
A nent A and B separately with a mechanical mixer primer application direct on steel. Ensure that
surfaces for best adhesion.
for minimum two minutes. brushes are clean. Pitted areas should be touched
up by brush before roller application.
Add components in correct mixing ratio

B
A
Dip brush often.
Work to limit edges by feathering. slowly into a clean tin. Then stir with a
C mechanical mixer for minimum two minutes.
Ensure that rollers are clean. Use a roller
Remove all particles and clean the surface board. Phenolic rollers with short hair are
Adhere to induction time and pot life recommended. Dip roller often. Over rolling
prior to painting. Paint immediately after
stated in the TDS before applying the paint. can cause paint pick up with fast drying paint.
the surface is prepared.

IMPORTANT IMPORTANT
Ensure surface is dry and free from contamination Consult the TDS for the correct Apply the last stroke in one direction
prior to application. mixing ratio and the correct hardener. to ensure a uniform finish.

HEALTH Avoid breathing in the vapours/fumes by working RECOMMENDED PERSONAL


in ventilated areas, and if necessary use respirator mask.
Use safety goggles or glasses. Avoid skin contact by wearing
PROTECTIVE EQUIPMENT: Do not paint under wet conditions: During
gloves and boiler suit.
Boiler suit
rain, high humidity (above 85%), snow, mist
and fog or surface wet with condensation.
High visibility vest or jacket
SAFETY Store the paint in a dry shaded area, preferably Consult the Safety Data Sheet (SDS),
in the paint locker. Assess and secure the area for flammable Ear protection
liquids or gases that may ignite when using mechanical power available for all products.
tools. Be sure to have good ventilation during painting Safety goggles or glasses
operations. Remove all naked lights and unprotected
See Onboard Maintenance Paint Guide
electrical equipment while painting. Safety helmet
or jotun.com for more information.
IMPORTANT
Safety boots and gloves Do not paint when the substrate temperature is under
ENVIRONMENT Do not allow the spillage of paint residues the minimum drying limit, or if dry to recoat maximum
to enter drains or water sources. Material and container must Respirator mask
be disposed as hazardous waste. painting interval is exceeded.
Safety harness

You might also like