0% found this document useful (0 votes)
71 views

NWU_Type_III_Quick_Fit_Guide

NWU

Uploaded by

422kennels
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
71 views

NWU_Type_III_Quick_Fit_Guide

NWU

Uploaded by

422kennels
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

HEAD GEAR: Navy Working Uniform (NWU) Type III OPTIONAL PATCHES:

• 8-Point cover with ACE logo is the “Standard Quick Fit Guide • Reverse U.S. Flag (worn on right shoulder)
Head Gear.” Revision Date: 26 May 2020 • Don’t Tread on Me flag (worn on left shoulder)
• Navy blue or coyote brown “Navy” or Command • Command Patch (if not worn on the right
ball cap is optional. breast pocket) can replace the DTOM.
• Worn squarely on head, parallel to the deck • Shoulder patches are laser cut or
above the ears and eyes. embroidered (patches worn must match).

WARFARE INSIGNIA:
T-SHIRT & UNDERGEAR:
• Single-Stack: Primary warfare insignia sewn
• Brown crewneck t-shirt. Collar should fit
centered above and flush with top
comfortably around neck.
edge of the U.S. NAVY Service
• Thermal underwear authorized but must not be
tape. Secondary insignia sewn
visible when wearing.
centered below and flush with
service tape.
RANK INSIGNIA: • Double-Stacked: Primary warfare insignia sewn
• Slip on embroidered (E-4 to O-10) centered above and flush with
• Muted gold (O-1 & O-4) secondary insignia (which is
• Black (all others) centered above and flush with
• Silver (optional for O-6) service tape).
• Fabric strip will extend a ¼ inch
SHIRT: on the left and right of the
• Worn squarely on shoulders. embroidery.
• Length should fall between bottom of crotch and
no further than the middle of the trouser cargo ROLLED SLEEVES:
pocket flap. • 3” wide band covered by cuff with
fabric side out.
TROUSERS: • Falls approx. 2” above elbow.
• Worn squarely on waist with 1 ¼”
cotton or nylon belt or 1 ¾” rigger belt SLEEVE LENGTH:
(E-1 to E-6 black belt) • Fully extended, cuffs fastened.
(E-7 to O-10 khaki/COY brown belt) • Should cover wrist bone but not extend
beyond first knuckle at base of thumb.

TROUSER BLOUSING:
• Blouse trousers using blousing straps or attached TROUSER LENGTH:
trouser drawstrings. When bloused, blousing • When not bloused, trouser leg length shall not
should cover top three rows of boot eyelets. extend below bottom of boot heel.

NWU BOOTS: PARKA & FLEECE:


• Laces must be tied and tucked into boots. WASH/CARE OF THE UNIFORM • To determine correct size and length,
• Boots should be fitted in, and worn with boot ALL BUTTONS/CLOSURES FASTENED try on parka with fleece and NWU
socks. AND SECURED shirt. Parka should cover fleece and
WASH THE UNIFORM INSIDE OUT the fleece should cover the shirt.

You might also like