Scribd
Upload
20 views

Crane Display Software Resetupdate

Uploaded by

kalai selvan
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
20 views

Crane Display Software Resetupdate

Uploaded by

kalai selvan
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

S E RV I C E I N F O R M AT I O N

625/1663 E rev.: - 2012-03-20

Crane Display Software Reset/Update

General Installation/update of MacHeavyvisor software


Software to be supplied by MacGregor is crane spe-
This instruction describes the reset/update of the cific.
crane display software. 1. Extract the supplied .zip files into the root folder of
an empty USB memory stick. Password = "mh".
Note! 2. Start the crane display (Power On).
The software reset/update must be performed by a 3. Attach the USB memory stick to the USB cable
competent person. attached to the crane display.
4. Tap the screen.
5. Follow the on screen instructions for the crane
Files needed display calibration. When calibration has ended
Installer.exe or UpdateHelper.exe (Application files) and the screen is white, tap the screen to save
MacHeavyvisor.CAB (Cabinet file) the calibration settings
6. Double click the "My Device" icon.
Equipment needed 7. Double click the "Hard disk" icon.
Computer 8. Double click the "Installer" or "UpdateHelper" icon.
USB memory stick 9. Follow the on screen instructions.
10. Turn off the crane display (Power Off).
11. Start the crane display (Power On).
Crane display software reset/update 12. The MacHeavyvisor software is now installed/
updated.
Before the software can be reset or updated you must
first reset the crane display.

Power On/Off
Reset crane display
1. Start the crane. Big Star
2. Turn off the crane display (Power Off).
3. On the crane display (see Fig. 1): Little Star
a) Push and hold down the Big Star button and
push the Power On button. LED Light
b) When the red LED light is steady lit, release the
Big Star button.
Note! Fig. 1 - Crane display
If the red LED light starts to flash the Big Star but-
ton was held for too long and the sequence needs
to be restarted from step 2.
4. In sequence, push;
a) Little Star button
b) Big Star button
c) Little Star button
5. Wait until the red LED light starts to flash and Win-
dows has fully started. This may take up to a minute.
6. Turn off the crane display (Power Off).

1 (2)
S E RV I C E I N F O R M AT I O N
625/1663 E rev.: - 2012-03-20

THIS PAGE IS INTENTIONALLY LEFT BLANK

2 (2)

You might also like