Scribd
Upload
29 views

Sections of SOLIDS

Uploaded by

cell7666081342
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
29 views

Sections of SOLIDS

Uploaded by

cell7666081342
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 12

Engineering Graphics

DS - 1005 ( C1 , C2 and E1)

Sections of Solids
Q.1. A square pyramid of base side 40 mm and axis 60 mm is resting on its base on the H.P. with
a side of base parallel to the V.P. Draw its sectional views and true shape of the section, if it is
cut by a section plane perpendicular to the V.P., bisecting the axis and is
(a) parallel to the H.P., (b) inclined at 60° to the H.P

(b)
Q.1. Cont’d

(b)
Q.1. Cont’d

(b)
Q.2. A square prism of base side 40 mm and axis 60 mm rests on its base on H.P. such that one
of the vertical faces is inclined at 30° to the V.P. A section plane perpendicular to V.P., inclined at
45° to H.P. passing through the axis at a point 20 mm from its top end cuts the prism. Draw its
front view, sectional top view and true shape of section
Q.2. Cont’d
Q.3. A square prism of base side 40 mm and axis 60 mm rests on its base on the H.P. such that
one of its rectangular faces is inclined at 30° to the V.P. It is cut by a section plane perpendicular
to H.P. and inclined at 60° to V.P. passing through the prism such that a face which is inclined at
60° to the V.P. is bisected. Draw its sectional front view, top view and true shape of section.
Q.3. Cont’d
Q.4. A sphere of diameter 60 mm is kept on the H.P. It is cut by an A.V.P. inclined at 45° to V.P.
The section plane passes through the sphere at a distance of 10 mm from the centre of the
sphere and in front of it. Draw its sectional front view, top view and true shape of the section
Q.5. A hexagonal prism of base side 30 mm and axis 70 mm is resting on a face on the H.P. with
axis parallel to the V.P. It is cut by a plane whose V.T. is inclined at 30° to the reference line and
passes through a point on the axis 20 mm from one of its ends. Draw its sectional top view and
obtain true shape of the section
Q.5. Cont’d
Q.5. Cont’d

You might also like