0% found this document useful (0 votes)
22 views

CP 01 Unit, Error, Measurement

Uploaded by

udaydebnath649
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
22 views

CP 01 Unit, Error, Measurement

Uploaded by

udaydebnath649
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

DPP Daily Practice Problems

Chapter-wise Sheets
Date Start Time: End Time:

PAYSICS CPO1
SYLLABUS:Physical World, Units&Measurements

Max. Marks : 180 Marking Scheme : (+4)for corect & (-1) for incorect answer Time:60 min.

INSTRUCTIONS: This Daily Practice Problem Sheet contains 45 MQs. For each question only one option is correct
Darken the corect circlel bubble in the Response Grid provided on each page.

1. The density of material in CGS system ofunits is 4g/am'. In 4. Young's modulus of a material has the same unit as that of
a system ofunits in which unitof length is 10cm and unitof a) pressure (b) strain
mass is 100 g, the value of density of material will be (e) compressibility (d) lorce
(a) 0.4 un it (b) 40 unit 5. Of the following quantities, which one has dimensions
(c) 400 unit (d) 0.04 unit different from the rema ining three?
The time period of a body under S.H.M. is represented by: (a) Energy per unit volume
T = P D° SE where P is pressure, D is density and S is (b) Force per unit arca
surface tension, then values of a, b and c are (c) Product of voltage and charge per unit vol ume
(d) Angular momentum
a) (b) - , -2, 3 The pressure on a square plate is measured by measuring
2
the force on the plate and length of the sides of the plate by
(c) 2' (d) 1,2, using the formula P = 5 . If the maximum errors in the
The respective number of significant figures for thenumbers 2
23.023, 0.0003 and 2.I x 10-S are measurement of force and length are 4% and 2%
respectively, then the maximum error in the measurement of
(a) 5, 1,2 6 ) 5,1,5 () 5,5,2 ( d ) 4,4,2
pressure is

a) % (b) % (d) 10%


C

RESPONSE 1. DOO 2. 0 0 0 3. 0 0 0 4. O©O5. 0 0


Gri»
6. @DO0|
Space for Rough Work
- DPP/ CP01
IP-2
7. The siemen is the SI unit of measurement of mass and length are 4% and 3%
(a) resistivity (b) resistance
respectively, the
density will be
maximum error in the measurement or

(c) conductiviny (d) conductance


8. An objectmoving through the liquid. The viscous
is (a) 7% ( b ) 9% (c) 12% (d) 13%%
16. Which is different from others by units ?
damping torce acting it is proportional to the velocity.
on

Then dimensions of constant of proportionality are (a) Phase di tterencee (b) Mechanical cquival ent
(a) MLT] (6) [MLT (c) Loudness of sound (d) Poisson's ratio
(c) [M°LT'] ofa d IMLT]| A quantity A 1S given by Egl where is the
9. Theleast cunt stop watch is 0.2 sccond. The time of 20
Oscillations of a pendulum is measured to be 25 second. permittivity ofthe free space, L is a length, DVis a potential
The percen tage error in the measurement of tume will be difference and Dr is a time interval. The dimensional fomula
(a) 0.1%
10.
a
Weber 1s the unit of
(6).8% O.8 for Xis the same as that of
(a) resistance (6) charge
(a) magnetic susceptbility (c) voltage (d) current
(0intensity of magnetisation
(C) magndic tux
18. Iftheerror in the measurement of the volume of sphere is
6%, then the error in the measureme nt of its surtace area will
(d) magnetic pemeability
11. The physical quantity which has the dimensional formula be
(a) b) (C)4% (d) 75%
[M'T
(a) surtace tension (b) solar constant 19. Ifveocity (V), force (F) and anergy (E) are taken as findamental
C) density (d) compressibility units, then dimensional formula for mass wall be
12. The dimensions of Wien 's constant are (a) VFE (b) V'FE (c)VF E (d) v FE
(a) [ML"TK] (b) [MLT°K] Multiply 107.88 and express the result
(c) [M°L"TKJ (d) [MLTK]
20.
by0.610 withcorrect
13. in
number of significant figures.
fthe capacitance ol nanocapacitor measured tems
a is
of a unit "u' made by combining the electric charge e, (a) 65.8068 (b) 65.807 (c) 65.81 ( d ) 65.8
Z1. Which of the
toll owing is a dmensional constant?
Bohr radius a , Plandk 's constant "h' and speed of light 'e
th en (a) Refractive index (6) Poissons ratio
h (C)Strain (d) Gravitational constant
(b)U= 22. IFE, m, Jand G represent enegy, mass, angular momentum
(a) u=-
(b) eao
and gravitational constant respectively, then the
dimensional formula of EJ/m°G is same as that of the
ec (d) u
(c) hag he
(a) angle (6) length )massS (d)time
23. The reiractive index of water measured by the relatin

14. The dimensions Tcal depth i s found to have values of 1.34, 1.38,
o E hca m
apparent depth
1.32 and 1.36; the mean val ue of refractive index with
(a) M'L3TA? (b) ML' T^A2
percentage error is
(c) M°LT°A" (d) M'LT*A
(a) 1.35+148% (b) 135+0%
15.
The density of a cube is mea sured by mcasuring its mass
and length of its sides. If the maximum error in the
(C) 1.36+6% (d) 136+0%

REsPONSE
7.
12.D00
@OO0 s. O000
13.0000
9.
14.0600
0 0 0 10.000
15.@O00
1. 000
16. O000
GrID 17.D0O 18.00©0 19.@O©0 20.@000 21. O00D
22.@O@@ 23.00O0
Work
Spacefor Rough
DPP/ CPO01
24. Ifeisthe chargs V the potential difference, T the temperature, 32. The mass of the liquid flowing per second per unit arca of
eV cross-section of the tube is proporti onal to (pressure
then the units of are the same as that of
difference across the ends" and (average velocity of the
(a) Planck's constant (b) Stefan's constant liquid". Which of the following relations between m and n
(c) Bolzmann's constant (d) gravitational constant IS correct?
25. The dimensions of mobilityare
(a) m=n(6) m=-n (c) mÉ=n (d) m=-n
(a) M*T-A (b) M-'T?A
33. The Richardson cquation is gi ven by I = A T - e , The
(C) M-T'A (d) MT'A
26. dimensional formula for AB is same as that for
Two quantities A and Bhave different dimensions which (d) Ik/T
mathematieal operation given below is physically
mcaningtul? 34.
a)
IT (b) kT c)
Turpentine oil is flowing through a capillary tube of length

27.
(a) A/B b) A+B (c)A-B (d) A-B
The velocity of water waves (v) may depend on their
and radius r. The pressure di ference between the two
ends of the tube is p. The viscosity of oil is given by :
wavclength I, the density of water r and the acceleration
due to gravity, g. The method of dimensions gives the
r-x
relation bctween these quantities is n= Here v is velocityof al at a distance x iram
(a) 4ve
(6) v* gA,
(d) vg'2 the axis of the tube. From this relation, the dimensional
28. The physical quantities not having same dimensions are formula of n is
(a) torque and work
(6) momentum and Planck's constant (a) [MLT'j (b) [MLT
(C)stresS and Young's modulus
(d) and
speed (m,e (c) [MLT1 (d) IM°LT
29. Aphysical quantity of the dimensions of length that can be
formed out o f c , G and i s [ c is v e l o c i t y o f l i g h t , G is S. Given that y = Asin| ct
where y and x are
47
universal constant of gravitation and e is charge] measured in metre. Which of the following statements is
true?
(a) The unit of A is same as that ofx and A
b
cG4TEo (6) The unit ofA is same as that ofx but not ofA
/2 ZT
(c) The unit of c is same as that of -

4TE
30. The unit of impulse is the same as that of (d) Theunit of (ct- x) is same as that of
(a) ener8Y power
(C) momentum (d) velocity 36. IfL=2.33 cm, B= 2.1 cm, then L+B=
31. 1f Q denote the charge on the plate of a capacitor of (a) 4431 am (b) 443cm (c) 44 cm (d) 4 cm
37. In the redation x= cos (a8 +kx), the dimensian(s) of o is/are
capacitanceC then the dimensional formula foris a) [M°LT] (6) IML-'T

(a) L M°T] (c) [M'LT-] (d) [M°LT]


b) L MTH
(c) [L-MT (d) [LM*T

24.@D00 25.000O 26.00©O 27.0600 28. OO0|


RESPONSE
Griv 29.0©0o 0.@000 31.@000 32.0000 33. 0©0
34.000 35.0©O 36.@O00 37.0©00
Space for Rough Work
- DPP/ CP01
38. Ina vernier callipers, ten smallest divisions of the vernier 42. Which of the following do not have the same dimensional
scale are equal to nine smallest division on the main scale. If formula as the velocity?
the smallest division on the main scale is halfmillimeter, Given that m, = permeability of free space,. e permittivity
then the vernier constant is of free space, n = fYequency,l= wavelength, P= press ure, r

(a) 0.5mm (b) 0.1 mm (c) 005 mm (d) 0.005 mm density, w= angular trequeney, k =wave number,
39. Which two of the following five physical parameters have
the same dimensions? (c)VP/p (d)ok
(A) Encrgy density (B) Refracti ve index 43. Unit of magnetic moment is
(C) Diclectric constant (D) Young's modulus (a) ampere-metre (6) ampere-metre
(E) Magnctic field (C)weber-metre? (d) weber/metre
(a) (B)and (D) (b) (C) and (E) 44. An experiment is performed to obta in the value of
(c) (A)and (D) (d) (A) and (E) acceleralion due to gravity g by using a simple pendulum of
length L. In this experiment time for 100 oscillations is
measured by using a watch of I second least count and the
40. In the cqn. |P+ V-b)= constant, the unit of a is
value is 90.0 seconds. The lengthL is measured by usinga
metr scale of least count I mm and the value is 20.0 am. The
(a) dyne cm* (b) dyne cm*
error in the determination of g would be:
(C) dyne/cm* (d) dyne cm*
(a) 1.7% (b) 2.7% ( ) 44% (d) 2.27%
41. The dimensions of Rcynold's constant are
45. for
(a) [M°LTM (b) [ML 'T'] The dimensional farmmula (6)
(a) [ML-TA]
magnetic flux is
[MLT"A)
(c)[ML-T) (d) [MLT] (c) [M'L*TA] (d) [ML'T'A]

RESPONSE 38.O000O 39.00OO 40.O00 41.®000 42. OO©0


GriD
43000 4.@0@0 45.@0@@
DAILY PRACTICE PROBLEM DPP CHAPTERWISE CPO1 PHYSICS
Total Questions 45
Total Marks 180
Attempted Correct
Incorrect Net Score
Cut-off Score 0 |Qualifying Score 70
Success Gap =Net Score Qualifying Score
Net Score= (Correct x4)-(Incorrect x1)_
- Space for Rough Hork

You might also like