0% found this document useful (0 votes)
70 views4 pages

Unit 6 Review Activity

Uploaded by

YLNZ
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
70 views4 pages

Unit 6 Review Activity

Uploaded by

YLNZ
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

TEC 040 UNIT 6 ACTIVITIES 6-1, 6-2, 6-3 Y.

NEWMAN

Review Activity 6-1


Analyze each of the section views shown below. Identify the type of section view, writing your
answers in the blanks at the bottom of the page.

1 HALF
2 REMOVED
3 OFFSET
4 ALIGNED
5 REVOLVED
6 BROKEN-OUT

Pg 1 of 4
TEC 040 UNIT 6 ACTIVITIES 6-1, 6-2, 6-3 Y.NEWMAN

Review Activity 6-2


For each of the numbers below, select the correctly drawn section view (A,B, C, or D), as cut
by a cutting plane parallel with a frontal plane at the midpoint o[the object. Place the letter of
the correct section view in the blank provided.

Pg 2 of 4
TEC 040 UNIT 6 ACTIVITIES 6-1, 6-2, 6-3 Y.NEWMAN

Review
B Activity 6-3
Section Views - for each of the numbers below, a front section view is missing. Place the
letter of the correct section view in the blank provided. Note: To make these problems a little
more challenging, center lines have been omitted!

Pg 3 of 4
TEC 040 UNIT 6 ACTIVITIES 6-1, 6-2, 6-3 Y.NEWMAN

Review Activity 6-3 (cont’d)

Pg 4 of 4

You might also like