Scribd
Upload
18 views

2002-2012 Jaguar X-Type Key FOB Remote Programming

Uploaded by

gonzalo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
18 views

2002-2012 Jaguar X-Type Key FOB Remote Programming

Uploaded by

gonzalo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

2002-2012 Jaguar X-Type Key FOB Remote Programming

Note: Every Remote you have must be programmed at the same time. If you only program one
remote and have other remotes already programmed it will render them useless unless you
program them again at the same time.

Note: These Instructions only program the 4 buttons on your remote. If you need a new key
programmed to start your vehicle and only have one key you will need to go to your local
Jaguar Dealer/Locksmith. If you have two keys programmed already all you need is a new key
cut you can program your 3rd and 4th keys yourself.

Ignition Tumbler Door Repair

When you pull the key out, does it still chime with car door open? When you press lock on your
remote does your vehicle beep and not lock? Look at the barrel in the ignition where you insert
the key, with the key removed there should be a little door that drops down over the hole, it
may be stuck open. If it is your remote won’t work. First wiggle the key as you take it out and
see if the door closes. If it doesn’t squirt a little WD40 in there and work the key in and out until
it does. Your remote should work after the door closes.

Method 1

1. Open driver's door.

2. Turn the ignition switch to the "auxiliary" position, then turn the ignition switch to the "ON"
position and back to the "auxiliary" position four times.

A chime from the Generic Electronic Module (GEM) will indicate programming status has been
enabled.

3. Turn the ignition switch to "OFF" position.

4. Remove the key from the ignition switch.

5. To program the transmitter, press any key within 10 seconds.

If the remote transmitter has been accepted, the GEM will make a chime.
6. If any other remote transmitters are to be programmed, press any button once on each
transmitter within 10 seconds.

7. Close driver door. Complete.

Method 2

1 Insert key into ignition

2 Turn key to 'II"

3 Turn key "III" and back to 'II' quickly 4 times

4 Alarm system will chime once when key is back to 'II' for the fourth time

5 Remove key from ignition

6 Press any button on each key fob and alarm system will chime for each fob if it has been
programmed correctly

7 Press unlock, lock, trunk etc. to make sure everything works

Method 3

1 Insert key into ignition

2 Turn key to 'I"

3 Turn key "II" and back to 'I' quickly 4 times

4 Alarm system will chime once when key is back to 'I' for the fourth time

5 Remove key from ignition

6 Press any button on each key fob and alarm system will chime for each fob if it has been
programmed correctly

7 Press unlock, lock, trunk etc. to make sure everything works

You might also like