AISIN LONG LIFE COOLANT (LLC)
WITH TRIPLE “P” TECHNOLOGY FEATURES
DESCRIPTION
Aisin Long Life Coolant Pre-mixed 20% (LCPM20A Series) is designed to use without further dilution with its freezing
point at -8 degree. It protects the metal materials used in the engine cooling systems from rusting. Aisin LLC is
designed based on JIS (Japan Industrial Standard) where it protects the engine from over-heating during the
summertime and anti-freezing over winter season. Anti-rust inhibitor used in Aisin Long Life Coolant prevents rusting
of metals such as iron, aluminum, copper, and brass that are used in automobile cooling systems. Non-amine anti-
rust agent used in Aisin Long Life Coolant does not contain any carcinogenic substance that is harmful to human
body.
PERFORMANCE STANDARDS
• Pre-mixed 20% (pre-diluted coolant available in red and green color)
CUSTOMER BENEFITS
• Anti-freeze Protection
- Prevent coolant freezing at extremely low temperature.
This bulletin was prepared in good faith from the best information available at the time of issue. While the values and characteristics are considered
representative, some variation, not affecting performance, can be expected. It is the responsibility of the user to ensure that the products are used
in the applications for which they are intended. Aisin, the Aisin logo, and related marks are trademarks of Aisin Asia Pte Ltd, used under license.
Copyright © 1Q23 UPDATE_JUNE AISIN ASIA Pte Ltd. All Rights Reserved
• Better cooling Performance
- Provides higher boiling points for protection against engine overheating.
• Anti-rust Prevention
- Designed to meet stringent corrosion protection and to prevent vehicle’s engine cooling system from depositing and
rusty.
PHYSICAL & PERFORMANCE DATA
Test method based on JIS K2234(Antifreeze)
Test Item Typical Spec. Typical Result
Appearance（Colour） Clear Red / Green Colour Clear Red / Green Colour
Density g/cm3（20℃） 1.036～1.040 1.038
Forming Tendencies ml 2 or less 0
pH 7.5～8.0 7.8
Freezing Point ℃ －8 or less －9.5
Cast Aluminium ±0.30 －0.02
Cast Iron ±0.15 －0.02
Weight Change
Steel ±0.15 －0.01
mg/cm2
Brass ±0.15 －0.03
Test Piece
Solder ±0.30 －0.02
Corrosion
Copper ±0.15 －0.03
Test
There should be no visible corrosion except
for the contact area between the test piece
Appearance pass
Undiluted and the spacer. Discoloration is not a
problem.
(With Corrosive
Additive) Liquid should not overflow from the
Forming Tendencies Pass
glassware.
88±2℃
pH 7.0～8.5 7.7
336±2h
pH Change ±0.5 －0.1
Liquid
Properties Colour should not change significantly. The
after test Liquid Phase liquid should not show any significant Pass
changes such as separation or gel formation.
Precipitate vol, ％ 0.5 or less 0.01 or less
This bulletin was prepared in good faith from the best information available at the time of issue. While the values and characteristics are considered
representative, some variation, not affecting performance, can be expected. It is the responsibility of the user to ensure that the products are used
in the applications for which they are intended. Aisin, the Aisin logo, and related marks are trademarks of Aisin Asia Pte Ltd, used under license.
Copyright © 1Q23 UPDATE_JUNE AISIN ASIA Pte Ltd. All Rights Reserved
