Scribd
Upload
28 views5 pages

Physics Revision Worksheet Grade X

Physics class 10 work sheet

Uploaded by

sampotawade
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
28 views5 pages

Physics Revision Worksheet Grade X

Physics class 10 work sheet

Uploaded by

sampotawade
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 5

D Y Patil High School

Physics Revision worksheet


Grade : X

1) Rays from sun converge at a point 15 cm in front of a concave mirror. Where should an
object be placed so that size of its image is equal to size of the object?
(a) 15 cm in front of the mirror
(b) 30 cm in front of the mirror
(c) between 15 cm and 30 cm in front of the mirror
(d) more than 30 cm in front of the mirror

2) A doctor has prescribed a corrective lens of power +1.5 D . The nature of the lens is
(a) diverging
(b) converging
(c) half diverging
(d) none of these
3) Study the following figure in which a student has marked the angle of incidence ( ∠ i ),
angle of refraction ( ∠ r ) , angle of emergence ( ∠ e ) ,angle of prism ( ∠ A ) , and angle of
deviation ( ∠ D ) . The correctly marked angles are:

(a) ∠ A and ∠ i
(b) ∠ A , ∠ i∧∠ r
(c) ∠ A , ∠ i ,∠ e∧∠ D
(d) ∠ A , ∠ i, ∠ r ∧∠ D
4) Velocity of light in air is 3 ×10 8m/s. While its velocity in a medium is 1.5 ×108 m/s. Then,
the refractive index of this medium is
(a) 3
(b) 5
(c) 0.5
(d) 2
5) Consider the following properties of virtual images
A. Cannot be projected on the screen
B. are formed by both concave and convex lens
C. are always erect
D. are always inverted
The correct properties are
(a) (A) and (D)
(b) (A) and (B)
(c) (A), (B) and (C)
(d) (A), (B) and (D)
6) A 10 mm long awl pin is placed vertically in front of a concave mirror. A 5 mm long
image of the awl pin is formed at 30 cm in front of the mirror, the focal length of this mirror
is
(a) -30cm
(b) -20cm
(c ) -40cm
(d) -60cm
8.Read the following and answer any 4 questions out of 5.
Light is a form of energy which induces sensation of vision to our eyes. It becomes visible
when it bounces off on surfaces and hits our eyes. The phenomenon of bouncing back of light
rays in the same medium on striking a smooth surface is called reflection of light.

If parallel beam of incident rays remains parallel even after reflection and goes only in one
direction is known as regular reflection. It takes place mostly in plane mirrors or highly
polished metal surfaces.
The mirror outside the driver side of a vehicle is usually spherical mirror and printed on such
a mirror is usually the warning “vehicles in this mirror are closer than they appear.”
i) Which type of mirror is used outside the driver’s side of a vehice?
(a) plane mirror (b) Concave mirror (c ) Convex mirror (d) either plane or convex
ii) No matter how far you stand from a mirror ,your image appers erect.
The mirror will be
(a) plane (b) Concave (c ) Convex (d) magic
iii) Which of the following diagrams represents the image formation in above case?
(a) I (b) ii (c ) iii (d) iv
iv) If an object is placed at 10cm from a convex mirror of radius of curvature 60cm, then find
the position of image.
(a)4cm (b)7.5cm (c ) 10cm (d) 12.5cm
v) The focal length of mirror is 12cm. the radius of curvature is
(a)12cm (b)24cm (c )20cm (d)36cm
9.Read the following and answer questions from (i) to (iv)
The phenomenon of splitting of white light into its constituent colours, when it passes
through a prism is called dispersion.
This band of seven colours so obtained, the VIBGYOR(V = violet, I = indigo, B = blue, G =
green, Y = yellow, O = orange and R = red) is called spectrum.
Issac Newton was the first one to use a glass prism to obtain the spectrum of light.

(i) The splitting of white light can be done by


(a) lens
(b) prism
(c) water drop
(d) both (b) and (c)
(ii) Which of the following diagram shows dispersion correctly?
(iii) When a red light passes through a prism, it will
(a) not split
(b) split into seven colors
(c) split into white color
(d) split into many different colors
(iv) Dispersion of white light by a prism is shown in the diagram below. What should be the
position of second prism in order to recombine the spectra and yield white light?

10.Observe the image given below and explain what is depicted.

11.Which defect is shown in the figure?


Write its correction mehod.

12..A spherical mirror produces an image of magnification -1.0 on a screen placed at a


distance of 30cm from the pole of the mirror.
i)Write the type of mirror in this case and find its focal length.
ii)What is the nature of the image formed?
iii) Draw the ray diagram to show image formation in this case.
13. Suppose you have three concave mirrors A, B and C of focal lengths 10cm, 15cm and
20cm.For each concave mirror, you perform the experiment of image formation for three
values of object distances of 10cm, 20cm and 30cm . By giving reason , answer the following
questions
i) For the three object distances, identify the mirror/ mirrors which will form an image of
magnification -1.
ii)Out of three mirrors identify the mirror which would be preferred to be used for shaving
purposes / makeup.
iii) For the mirror B draw ray diagram for image formation for object distances 10cm and
20cm.

You might also like