Scribd
Upload
183 views

Perlin Design P

This document provides calculations for designing a purlin with a span of 3.6 meters and 0 degree roof angle. It calculates the total load on the purlin, required section modulus, and checks the designed section for bending stress and deflection. The designed built up section with section modulus of 16 cm^3 and moment of inertia of 104.2 cm^4 satisfies the permissible bending stress of 165 N/mm^2 and allowable deflection of 11.077 mm.

Uploaded by

viren224
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
183 views

Perlin Design P

This document provides calculations for designing a purlin with a span of 3.6 meters and 0 degree roof angle. It calculates the total load on the purlin, required section modulus, and checks the designed section for bending stress and deflection. The designed built up section with section modulus of 16 cm^3 and moment of inertia of 104.2 cm^4 satisfies the permissible bending stress of 165 N/mm^2 and allowable deflection of 11.077 mm.

Uploaded by

viren224
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

PURLIN 1) Input Span of purlin Roof angle Spacing of purlin

(p)

(l)

= = = mm

3.6 m 0 deg 1.15 m

Thickness of slab above crest of deck Effective Slab thickness for deck with

0 Mm Depth corrugation = = 0.0 + 0.0/2 0 mm

2) Loading Dead load of purlin Dust load on roof Dead load of Roof slab (0.000x 25) Self weight of 0.8 mm deck sheet Dead Load Live Load Total load on the Roof slab 3) Analysis Total load on purlin (DL+LL) Design load Design moment (M) = wl^2/8 Maximum Shear (V) = wl/2 Permissible bending stress (bc) (w ) 1 = = = 0.16 KN/m^2 0.5 KN/m^2 0.00 kN/m^2
(ASSUMED) (ASSUMED)

= = = =

0.1 kN/m^2 0.76 kN/m^2 0.51 kN/m^2 1.3 kN/m^2

= = = = =

1.6205 KN/m 1.6205 KN/m 2.6 K Nm 2.9169 k N 165 N/mm^2

Section modulus required

= M / bc = = 15910 mm^3 15.91 cm^3

Use Built up section Section modulus Moment of inertia Zxx Ixx = = 16 cm^3 104.2 cm^4

For this section calculated bending stress ' 4) Check for deflection Calculated deflection of section cal = (5/384)*wl^4/(EI) = 17.01 Allowable deflection allow = l/325 = 11.077 mm > 17.0 mm mm bc (cal) = 164.0756 N/mm^2 < 165 N/mm^2 OK

You might also like