Scribd
Upload
168 views

Reset Actuator

The document provides instructions for erasing the memory of a 7D1-40 transfer control system. The procedure involves preparing short harness needles, turning off the ignition, accessing the controller under the front left seat, connecting the harness to the controller connector with the ignition on briefly to trigger a relay sound, then disconnecting and turning the ignition on again to confirm the 4WD lamp is off, and checking actuator circuits are normal before erasing memory.

Uploaded by

Dona Randria
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
168 views

Reset Actuator

The document provides instructions for erasing the memory of a 7D1-40 transfer control system. The procedure involves preparing short harness needles, turning off the ignition, accessing the controller under the front left seat, connecting the harness to the controller connector with the ignition on briefly to trigger a relay sound, then disconnecting and turning the ignition on again to confirm the 4WD lamp is off, and checking actuator circuits are normal before erasing memory.

Uploaded by

Dona Randria
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

7D1-40 TRANSFER CONTROL SYSTEM

Memory erasing procedure


1. Prepare two pieces of short harness with the end sharped like a needle (bout 20cm(7.9 in) long). 2. Turn OFF the ignition. 3. Remove the front left seat ASM. 4. Make the controller under the front left seat ASM (spread the cut of the floor carpet).

5. Keeping the connector of the transfer controller connected, set the short harness from the back of the connector as illustrated. 6. Turn ON the ignition, wait for 2 seconds, and turn OFF the ignition after confirming the relay sound. 7. Disconnect the short harness, turn ON the ignition again, and confirm the Check 4WD lamp in the meter panel is OFF. 8. Before erasing the memory, check that the circuit of the T/F actuator position detection harness, etc. for it are normal.

Transfer Controller Pin Assignment

RTW47DSF000101

You might also like