Humidity Calculator Page 1 of 3

Home | About Us | Contacts | Help | Feedback |

SEARCH

Global | Australia | NSW | Vic. | Qld | WA | SA | Tas. | ACT | NT | Ant. |

Weather & Warnings | Hydrology | Climate | Numerical Prediction | About Services | Learn About Meteorology | Registered
User Services |

Humidity Calculator

For other conversion calculators go to the following links

Pressure | Rainfall | Temperature | Speed

Dry-bulb: 32 Dew-Point: 15 Calculate

Estimated RH(%): 36

Measuring Humidity

Humidity can be measured indirectly with dry and wet-bulb thermometers. The
dry-bulb is an ordinary mercury-in-glass thermometer and measures the air
temperature (see Figure 1).

The bulb of the wet-bulb thermometer is covered by a muslin bag which is kept
moist. It gives a lower reading than the dry-bulb because of the cooling effect of
water evaporating from the muslin bag (see Figure 1).

The two thermometers may be placed in a Stevenson screen, or whirled together

in a sling (sling psychrometer), or ventilated by drawing air past them with an
electric fan (aspirating psychrometer).

The actual readings of the two thermometers and the difference between them
enable us to calculate all the humidity quantities defined in the 'Humidity
Definitions' given below.
Figure 1
Dry-bulb (left) and The difference between the wet and dry-bulb readings is a good indication of the
wet-bulb (right) efficiency of evaporative-type coolers and the wet-bulb reading is a reasonable
thermometers. indication of human comfort.

Humidity Definitions

Humidity is essentially the number of water vapour molecules in the air, but there
are many and varied ways of expressing it. All of these terms are used
scientifically, but humidity figures provided for public use in newspapers are
usually relative humidity.

http://www.bom.gov.au/lam/humiditycalc.shtml 08/02/2009
Humidity Calculator Page 2 of 3

Figure 2
Change in amount of water vapour in saturated air with temperature.
The air's capacity for water vapour increases as air temperature increases.
Air with a temperature of 30°C can hold more than three times
as much water vapour as air at 10°C.

Absolute humidity
The mass of water vapour in a unit volume of air. It is a measure of the actual
water vapour content of the air.

Specific humidity
The mass of water vapour per unit mass of air (including the water vapour). It is
another measure of the actual water vapour content of the air.

Mixing ratio
The mass of water vapour per unit mass of dry air (excluding the water vapour).
Another measure of the actual water vapour of the air.

Vapour pressure
The partial pressure of the water vapour. Yet another measure of the actual
water vapour content of the air. (Air pressure is the sum of the partial pressures
of the gases comprising the air.)

Saturation
The air is saturated with water vapour when it holds as much water vapour as it
can at that temperature.

Saturated vapour pressure

The water vapour pressure when the air is saturated.

Dew-point
The temperature to which air must be cooled (at constant pressure and constant
water vapour content) for saturation to occur.

Frost point
When the dew-point falls below freezing it is called the frost point.

Wet-bulb temperature
In simple terms, the lowest temperature to which air can be cooled by
evaporating water into it.

http://www.bom.gov.au/lam/humiditycalc.shtml 08/02/2009
Humidity Calculator Page 3 of 3

Relative humidity (RH)

The ratio of the actual amount of water vapour in the air to the amount it could
hold when saturated expressed as a percentage OR the ratio of the actual
vapour pressure to the saturation vapour pressure expressed as a percentage.

The amount of water vapour the air can hold increases with temperature.
Relative humidity therefore decreases with increasing temperature if the actual
amount of water vapour stays the same.

Figure 3
Relative humidity varies significantly when the temperature changes,
even when the actual amount of water vapour in the air remains the same.

Temperature ________
Relative Humidity _ _ _ _

Relative humidity =

The actual amount of water vapour in the air x 100%

The amount of water vapour required to saturate the air at that temperature

OR

The actual vapour pressure x 100%

The saturated vapour pressure at that temperature

Home | About Us | Learn about Meteorology | Contacts | Search | Help | Feedback

Weather and Warnings | Climate | Hydrology | Numerical Prediction | About Services | Registered Users | SILO

© Copyright Commonwealth of Australia 2009, Bureau of Meteorology (ABN 92 637 533 532)
Please note the Copyright Notice and Disclaimer statements relating to the use of the information on this site and our site Privacy
and Accessibility statements. Users of these web pages are deemed to have read and accepted the conditions described in the
Copyright, Disclaimer, and Privacy statements. Please also note the Acknowledgement notice relating to the use of information on
this site. No unsolicited commercial email.

http://www.bom.gov.au/lam/humiditycalc.shtml 08/02/2009