Paper craft 50K Assembly instructions 1/1

What to prepare Assembly procedure

● Paper that is somewhat thick 1. Print out the parts pages with a printer.
● Scissors, cutter ● Cutter mat 2. Before cutting a part, write its part number on the back of it with a pencil.
● Ruler ● Pencil ● Tweezers 3. Before cutting a part, use a ballpoint pen that can no longer write, or a stylus,
● Ballpoint pen that can no longer write, or stylus to trace along its fold lines and make creases.
● Adhesive (strong adhesive is recommended) 4. Cut out the part along the cut-out line.
● String 5. Fold the dotted line according to the instructions for mountain-folding and valley-folding.
6. Glue and assemble the various parts according to the illustrations.

Explanation of symbols
Cut-out line Slit-cutting line Cut-through Glue Glue to the front of another part
Mountain fold line Valley fold line 1,2... Part numbers Glue within the same part Glue to the back of another part

Notes
・When using scissors, cutters, adhesives, etc. that may be dangerous to infants, keep them out of infants’ reach.
・When using scissors or a cutter, be careful not to cut your fingers, etc.
・Be careful not to get injured by the cross section or edge of the paper.

1 Assembly of “ ” 2 3 4
6
Glue the area indicated with “ ” on the
part within the same part. Assemble all
other parts marked with 1
“ ” in the same way.
5

4
3
4
2

5 6 7 * The required string length may vary depending

13 20 on the assembly method. Assemble while

adjusting the string length, using the length
shown in the figure as a guide.

19 Tie the string into a loop, About 230 mm

10 then insert and glue 23
a
8 9 7
the center of the string
21 e
18
with Part 21. b 23
Insert
22 d

15 17 c a

12 a
* Assemble in sequence
16 starting from “a” .

11
14 About 110 mm

About 110 mm

8 9
27 24 Hook the string on
25 Part 27. Hook the string on
28
26 27
Part 24.
30
b
b
c b
b

d c
d
24

a
29
About 160 mm

Tie the string into a loop,

then insert with Part 29 and 30.
Hook the string on Part 24 and
* Assemble in sequence starting from “a” . glue Part 29 and 30 to the body.