Certificate No. : 2433 Caution : Contents under pressure. do not Date of Analysis : 29/06/2024 puncture or use near an open Flame Name of Party : AMBETRONICS ENGINEERS PVT. LTD. Refer to the appropriate phoenix instruction Manual or Operator’s Manual for detailed P.O No & Date : 2324PO0680 Date: 13/06/2024 instruction about the gas pressure and flow adjustment Remove the block Nut / Seal if present and identity Technical specification the cylinder valve for left hand or right hand Filling Pressure : 100 Kg/Cm2 Attach the gas regulator to the gas Cylinder Preparation Tolerance : +/-10% Open the gas Cylinder valve and observe the inlet pressure in the regulator Certification Accuracy : +/-2% Flush the regulator with the cal gas in order to Cylinder No. : CT-2171 condition it Cylinder Capacity : 0.5 Ltrs WARRANTY : Phoenix provides products which, under normal Sr. No Components Order Conc. Certified Conc condition of use, meet stated specifications. Gas products should be utilize only with equipment 1 Chlorine 12 PPM 15 PPM constructed of compatible materials. Gases Under 2 Air Balance Balance pressure present inherent hazards to the user Validity Of Certificate 06 month from the date of Analysis and to the equipment and it can only be assumed Cylinder Basis that the user has basic knowledge in the use and Refilling limitations of the refilling of a gas container by Traceability The Reference standards are gravimetric/volumetric filled the user automatically void any manufacturers Mixture were on the standard weights are traceable to liability NPL,New Delhi Whose reference standards are traceable to WARNING : GAS CYLINDER’S RULES 2016 NIST.Certificate No. IN3591-008-062624-ACC-NABL Valid up Do not change the colour of the cylinder. to 26-06-2025. Certificate no 2023-24/CCL/193 Valid Up to This cylinders should not be filled with any gas other 17-01-2025. than the one it now contains. No flammable material should be stored in the immediate vicnity of the cylinder or in the same room in which it is kept. No oil similar Lubricant should be used on the valves or other filling of the cylinder