Scribd
Upload
12 views4 pages

02-Clipping Clamping

Uploaded by

muraliece muraliece
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
12 views4 pages

02-Clipping Clamping

Uploaded by

muraliece muraliece
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

CLIPPING AND CLAMPING CIRCUITS

AIM

To realise different clipping and clamping circuits and observe the waveforms.

THEORY

Clipping Circuits

Clipping circuits are nonlinear wave shaping circuits. A clipping circuit is useful to cut
off the positive or negative portions of an input waveform. Clipping circuits are also known as
voltage limiters or slicers.

Positive clipper

The positive half cycle is clipped by diode and only the drop across diode will appear
across the load. During negative half cycle, the diode does not conduct and the voltage across
RL is given by
R
V V L

L S R
RL

Since RL >> R, the output voltage will be close to input voltage during negative half
cycle.

Negative clipper

The negative half cycle is clipped by diode and only the drop across diode will appear
across the load. During positive half cycle, the diode does not conduct and the voltage across
RL is given by
R
V V L

L S R
L  R

Since RL >> R, the output voltage will be close to input voltage during the positive half
cycle.

Biased positive clipper

Here a reference voltage is given to the clipper circuit by a zener diode. Up to Vz, the
output voltage is

V0 = Vin RL /(RL+R)

At Vo = Vz, the zener breakdown occurs and the voltage Vo is constant. Here the reference
voltage is used to clip only a part of the positive half cycle.

1
Biased negative clipper

The principle is similar to that of a biased positive clipper. Here a reference voltage is
provided by a zener diode to clip a portion of the negative half cycle. During the positive half
cycle

V0 = Vin RL/(RL+R)

Slicer

This is the combination of both biased positive clipper and biased negative clipper. The
peak portion of the signal determined by the zener voltage reference is clipped.

Clamping Circuit

Clamping is a function which must be frequently performed with a periodic waveform


in the establishment of the recurrent positive or negative extremity at some constant reference
level. Clamping circuits are also referred to as dc restorer or dc inserter.

A positive clamper adds positive dc level and a negative clamper adds a negative dc
level. A positive clamper clamps a negative extremity of the input signal to the reference
voltage level. A negative clamper adds to negative dc level by clamping the positive extremity
of the input to the reference voltage level.

PROCEDURE

The circuits are wired as in the circuit diagram. Connect the input terminals to 230V ac
supply and the output terminals to a CRO.

2
Positive clipper

Negative clipper
VS
t

0.6 V
VL

You might also like