Scribd
Upload
11 views

Modul 4-1 DataLink Layer

Uploaded by

jefersonmaxdaniel
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
11 views

Modul 4-1 DataLink Layer

Uploaded by

jefersonmaxdaniel
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 20

DataLink Layer

[email protected]
Electronic Engineering Polytechnic Institut of Surabaya – ITS
Kampus ITS Sukolilo Surabaya 60111
Pendahuluan

 Merupakan Layer 2 pada Model OSI


 Bertujuan menyediakan koneksi antara dua
komputer/host dengan menggunakan
pengalamatan secara fisik/Hardware Addressing
 Komunikasi hanya bisa terjadi jika kedua
host/komputer yang berkomunikasi tahu alamat
fisik masing-masing
 Pengalamatan secara fisik biasa disebut MAC
Address
 MAC Address Diambilkan dari ID NIC masing-
masing komputer

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
MAC (Media Access Control) Address

 MAC Address terdiri dari


48 bit tetapi biasanya
ditulis dalam 12 bit
Heksadesimal dengan
ketentuan 6 bit sebagai
kode pabrik yang
ditentukan oleh IEEE dan 6
bit berikunya adalah
nomor serial peralatan
yang dikeluarkan oleh
pabrik

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Pengiriman Data

 Untuk melakukan pengiriman data diperlukan kombinasi


antara pengalamatan secara fisik dan pengalamatan secara
logik
 pengalamatan secara logik biasa disebut dengan IP Address
(nomor IP), berada pada layer network
 Nomor IP diperlukan oleh perangkat lunak untuk
mengidentifikasi komputer pada jaringan
 Namun nomor identitas yang sebenarnya diatur oleh NIC
(Network Interface Card) atau kartu Jaringan yang juga
mempunyai nomor unik.

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Pengiriman data pada DataLink Layer

 Penentuan waktu pengiriman data yang tepat apabila suatu


media sedang terpakai, hal ini perlu melakukan suatu deteksi
sinyal pembawa.
 Pada Ethernet menggunakan metode Carrier Sense Multiple
Access / Collision Detection (CSMA/CD).
 Pada jaringan yang dapat melakukan akses secara bersamaan
simultan. Maka bila Host A mengirimkan data ke Host D, maka
Host B dan C akan melakukan deteksi jalur, dan apabila jalur
sedang dipakai maka Host B dan C akan menunggu terlebih
dahulu.

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Metode CSMA/CD

 sebuah host komputer yang akan mengirim data ke jaringan


pertama-tama memastikan bahwa jaringan sedang tidak
dipakai untuk transfer dari dan oleh host komputer lainnya
(Listen).
 Jika pada tahap pengecekan ditemukan transmisi data lain
dan terjadi tabrakan (collision), maka host komputer tersebut
diharuskan mengulang permohonan (request) pengiriman
pada selang waktu berikutnya yang dilakukan secara acak
(random).
 Dengan demikian maka jaringan efektif bisa digunakan secara
bergantian

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Error Checking Pengiriman Data

 Data-Link dapat melakukan deteksi error dan


memberikan peringatan (notification) kepada
lapisan diatasnya,bahwa terjadi kesalahan
transmisi.
 Teknik yang digunakan error ddetection adalah
Frame Check Sequence (FCS) dan Cyclic
Redundancy Check (CRC).
 Data Link tidak melakukan error-correction

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Data Pada DataLink Layer

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Generic Data Link Frame Format

Preamble or Start Field


 When computers are connected to a physical medium, there must be a
way they can grab the attention of other computers to broadcast the
message, "Here comes a frame!"
 Various technologies have different ways of doing this process, but all
frames, regardless of technology, have a beginning signaling sequence of
bytes.
 Depending up frame format: Preamble = 7 bytes, Start or Start of Frame
Delimiter (SFD) = 1 byte
[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Generic Data Link Frame Format

Address Field
 We saw how IEEE 802.3 uses Destination and Source Addresses.

 By the way: Any idea how a serial data link frame is addressed?

 Unicast address – Single device


 Broadcast address – All devices
 Multicast address – Specific group of devices

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Generic Data Link Frame Format

Type Field
 Usually information indicating the layer 3 protocols in the data field, I.e. IP Packet.
 Type field values of particular note for IEEE 802.3 frames include:
 0x0600 XNS (Xerox)
 0x0800 IP (the Internet protocol)
 0x8137 Novell NetWare packet formatted for Ethernet II
 0x6003 DECNET

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
“Ethernet” Frame Formats

Length Field
 In some frame formats such as 802.3, there is a length field which specifies
the exact length of a frame.

802.3

802.3 Electronic Engineering


[email protected] 802.2Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
 IEEE 802.3 specification limits the data portion to a maximum of 1500 bytes.
 Designed to hold a Layer 3 IP packet.
 When IEEE created 802.2, it saw the need for a protocol TYPE field that identified what
was inside the “data” field.
 IEEE called its 1 byte type field DSAP (Destination Service Access Point).
 Turned out that 1 byte was not long enough to handle all the different number of
protocols.

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
1. To accommodate more protocols IEEE added the SNAP
(Subnetwork Access Protocol) header.

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
 The fields of various Ethernet framing that are used for
identifying the type of data contained in a frame:
 Ethernet II or DIX (DEC, Intel, Xerox) – Most common

 IEEE Ethernet (802.3)

 IEEE 802.3 with SNAP header

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Generic Data Link Frame Format

Data Field
 Included along with this data, you must also send a few other bytes.

 They are called padding bytes, and are sometimes added so that the
frames have a minimum length for timing purposes.
 LLC bytes are also included with the data field in the IEEE standard frames.
(later)

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Data Encapsulation Example

Application Application Layer


Header + data

Layer 4: Transport Layer

Layer 3: Network Layer

Layer 2:
Network
Layer
010010100100100100111010010001101000… Layer 1: Physical
Layer

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Generic Data Link Frame Format

FCS
 Used to insure that the data has arrived without corruption.

 More efficient than sending the data twice and comparing


the results.
 Necessary to prevent errors.

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Three Kinds of FCS

 Cyclic redundancy check (CRC)


 performs polynomial calculations on the data
 Two-dimensional parity
 adds an 8th bit that makes an 8-bit sequence have an odd or even
number of binary 1s
 Internet checksum
 adds the numbers to determine a number

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111
Generic Data Link Frame Format

Stop Field (Other data link frame formats)


 The computer that transmits data must get the attention of other devices,
in order to start a frame, and then claim it again, to end the frame.
 The length field implies the end, and the frame is considered ended after
the FCS.
 Sometimes there is a formal byte sequence referred to as an end-frame
delimiter.

[email protected] Electronic Engineering Polytechnic Institut of Surabaya – ITS Kampus ITS Sukolilo 60111

You might also like