Scribd
Upload
55 views

CSI Linux - Connecting To Tor

Uploaded by

aneeshshinde167
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
55 views

CSI Linux - Connecting To Tor

Uploaded by

aneeshshinde167
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Using Tor in CSI Linux

This will walk through how to connect to Tor with CSI Linux.
Using Tor with CSI Linux
CSI Linux was built for cyber investigations starting from OSINT to computer/mobile/network forensics.
When focusing on the OSINT, CSI Linux has taken special care to give investigators a secure option to help
them protect their identity. You do not have to use Tor, but there have been two options we have designed
to ensure if you do that you will be safe along with allowing your tools to still be able to connect to Tor
.onion sites. This is critical for Dark Web investigations.

Both of these options are preventing your internet facing IP address from being identified by those under
investigation while allowing all of your tools to naturally go through Tor.

Option 1: CSI_TorVPN

This option allows for your system to encapsulate ALL of your network traffic through built in Tor entry
node similar to Tails (https://tails.boum.org/). The difference is this is not a burnable temporary system
that destroys your data after use (very useful in certain situations).

1. Run the CSI_TorVPN application.


2. Choose the network adapter that has an internet connection.

3. Turn the CSI_TorVPN “On” or “Off”

4. Enter the CSI password (default csi)

5. When you connect to Tor, you should see a


1. different address pop up.
6. To turn the CSI_TorVPN off, follow same
2. steps and change step 3 to “Off”.

© CSI Linux – csilinux.com 1


Option 2: CSI_Gateway

This option is only available in the Virtual Appliance and uses the Whonix gateway
(https://www.whonix.org/) to tunnel ALL of your traffic through Tor. Once you download, install, and
run the Whonix gateway, if you run the CSI_Gateway application, it will reconfigure CSI Linux to work
with Whonix. As long as Whonix is connected to Tor, all your traffic in CSI Linux will be routed through
Tor.

1. Start Whonix Gateway


2. Start CSI Linux

3. Run the CSI_Gateway application.


4. Choose the network adapter that has an internet connection.
5. Turn the CSI_Gateway “On” or “Off”.

7. Enter the CSI password (default csi)

8. To turn the CSI_Gateway off, follow same steps and change step 5 to “Off”.

Option 3: Network Tor Gateway

Set up a network device as a Tor relay and route your traffic through that gateway.

If you would like to be involved in the future development of CSI Linux, please contact us at
[email protected]

© CSI Linux – csilinux.com 2

You might also like