0% found this document useful (0 votes)
13 views

Exp 4

Uploaded by

pilawak670
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
13 views

Exp 4

Uploaded by

pilawak670
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Princess Sumaya University for Technology

The King Abdullah II School for Electrical Engineering


Electronics Engineering Department

Digital Electronics’ Lab

In Lab Report

Experiment 4:

CMOS Logic Characteristics

Names of Group: 1. ……………………….................................. ID#:……………………………


2. ……………………….................................. ID#:……………………………
3. ……………………….................................. ID#:……………………………

Group No.:
Section:
Date: / /
Objectives
…………………………………………………………………………………………………………………………………………………..
.………………………………………………………………………….………………………………………………………………………

A) Transistor Switch
1.Connect the Circuit Shown in figure 1.

2.Complete The following table.

Vin(DC) Vout(DC)
0
5

Table ‐1‐
Figure ‐1‐
3. Complete Table 2.

Measurement Waveforms

For Vin= 5 Vp‐p @ 1kHz with 2.5V


DC Offset
In X‐Y mode:
a. Draw the X‐Y waveforms

b. Record
VIL = ………………..
VIH = ………………..
VOL = ………………..
VOH= ………………..

Table ‐2‐
NMH= VOH‐VIH= ………………………………………………………………………………………
NML = VIL‐VOL= …………………………………………………………………………………………
1.Connect the Circuit Shown in figure 1.

Figure -1-
Complete Table 1.

Measurement Waveforms

For Vin= 5 Vp-p @ 1kHz


with 2.5V DC offset.

In X-Y mode:
c. Draw the X-Y
waveforms

d. Record
VIL = ………………..
VIH = ………………..
VOL = ………………..
VOH= ………………..

Table -1-
2.Connect the circuit Shown in Figure
2. And Find the measurements shown
in Table 2.

Measurements
VIH
VOL
IIH(calculated)
Table -2-

Figure -2-

3.Connect the circuit Shown in Figure


3. And Find the measurements shown
in Table 3.
Measurements
VIL
VOH
IOH(calculated)
Table -3-

Figure -3-
4.Connect the circuit shown in Figure 4.( Pin 14=5V, Pin 7= GND)

Figure -4-

a. Find To= Propagation-Delay-Time= ............................... s.


b. Find the APDT ( Average Propagation Delay Time)= To , Where n= no. of
gates -1. 2n
APDT=................................ s.

You might also like